RS485-C2(UN) Equinox Technologies, RS485-C2(UN) Datasheet - Page 18

• Manufacturer Part Number: RS485-C2(UN)
• Description: CONVERTER KIT, COMMS, RS485
• Manufacturer: Equinox Technologies

Specifications of RS485-C2(UN)

• Development Tool Type: Converter Module
• Supply Current Max: 1000mA
• Supply Voltage Dc Max: 9.9V
• Supply Voltage Dc Min: 8.3V
• Supported Devices: PPM3-MK2
• Tool / Board Application: Equinox PPM3-MK2 Programmer
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

4.2 PRO104/108 Hardware Installation Instructions
Figure 12
RS232-RS485 Convertor Manual V1.02 28/06/01
Place the PRO104/108 programmer(s) on a flat surface allowing sufficient space in front
of each programmer to place the ‘ISP Interface Modules’ and ‘Target Systems’.
Plug the 9-way RS-232 cable into the port on the RS-232 to RS-485 convertor.
Plug an RS-485 network cable from one of the RS-485 outputs on the RS-485 convertor
to the ‘RS-485 Input’ connector on the rear panel of the first PRO104.
Plug another RS-485 network cable from the ‘RS-485 Output’ connector on the rear
panel of the first PRO104/108 to the next PRO104/108 in the chain.
A return RS-485 cable from the last PRO104/108 in the chain to the RS-485 convertor is
NOT required.
Power up the PC
Power up the PRO104/108 programmer(s)
Launch the ISP-PRO software on the PC and set up the required number of PPM’s
within the software
Test that all PPM’s are communicating with the PC at their correct ‘Node Address’. (The
Node Address may be changed while the programmer is powered up).
9