LQ035Q3DW02 Sharp Microelectronics, LQ035Q3DW02 Datasheet - Page 25

• Manufacturer Part Number: LQ035Q3DW02
• Description: DISPLAY, LCD GRAPHIC, 320 X 240 DOTS
• Manufacturer: Sharp Microelectronics

Specifications of LQ035Q3DW02

• Viewing Area (h X W): 52.92mm X 70.56mm
• Supply Voltage: 3.3V
• Length/height, External: 76.9mm
• External Width: 63.9mm
• External Depth: 3.5mm
• Display Mode: Transmissive
• Rohs Compliant: Yes
• Lcd Display Type: TFT
• Interface Type: Serial, SPI
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

10-5. Others
3) How the remove dust on the polarizer
4) In the case of the module’s metal part (shield case) is stained, wipe it with a piece of dry, soft cloth.
5) If water dropped, etc. remains stuck on the polarizer for a long time, it is apt to get discolored or cause
6) As a glass substrate is used for the TFT-LCD panel, if it is dropped on the floor or hit by something hard,
7) Since CMOS LSI is used in this module, take care of static electricity and take the human earth into
1) Regarding storage of LCD modules, avoid storing them at direct sunlight-situation.
2) If stored at temperatures below the rated values, the inner liquid crystal may freeze, causing cell
3) If the LCD is broken, do not drink liquid crystal in the mouth. If the liquid crystal adheres to a hand or
4) If a water drop or dust adheres to the polarizer, it is apt to cause deterioration. Wipe it immediately.
5) Be sure to observe other caution items for ordinary electronic parts and components.
stains. Wipe it immediately.
If rather difficult, give a breath on the metal part to clean better.
it may be broken or chipped off.
consideration when handling.
destruction. At temperatures exceeding the rated values for storage, the liquid crystal may become
isotropic liquid, making it no longer possible to come back to its original state in some cases.
foot or to clothes, immediately cleanse it with soap.
a) Blow out dust by the use of an N2 blower with antistatic measures taken. Use of
b) When the panel surface is soiled, wipe it with soft cloth.
an ionized air Gun is recommendable.
LD-20302A -23