LQ035Q3DW02 Sharp Microelectronics, LQ035Q3DW02 Datasheet - Page 25

• Manufacturer Part Number: LQ035Q3DW02
• Description: DISPLAY, LCD GRAPHIC, 320 X 240 DOTS
• Manufacturer: Sharp Microelectronics

Specifications of LQ035Q3DW02

• Viewing Area (h X W): 52.92mm X 70.56mm
• Supply Voltage: 3.3V
• Length/height, External: 76.9mm
• External Width: 63.9mm
• External Depth: 3.5mm
• Display Mode: Transmissive
• Rohs Compliant: Yes
• Lcd Display Type: TFT
• Interface Type: Serial, SPI
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

10 Handling of modules
10-1. Inserting the FPC into its connector and pulling it out
10-2. handling of FPC
10-3. Mounting of the module
10-4. Cautions in assembly / Handling pre cautions
1) Be sure to turn off the power supply and the signals when inserting or disconnecting the cable.
2) Please insert for too much stress not to join FPC in the case of insertion of FPC.
1) The bending radius of the FPC should be more than R0.6mm, and it should be bent evenly.
2) Do not dangle the LCD module by holding the FPC, or do not give any stress to it.
1) The module should be held on to the plain surface. Do not give any warping or twisting stress to
2) Please consider that GND can ground a modular metal portion etc. so that static electricity is not
As the polarizer can be easily scratched, be most careful in handling it.
1) Work environments in assembly.
2) Instruction for working
the module.
charged to a module.
The best distance of use blower
Since removing laminator may causes electrostatic charge that tends to attract
following work environment would be desired.
a) Wind direction of an antistatic blower should slightly downward to properly blow the module.
a) Floor: Conductive treatment having 1MΩ resistance onto floor’s tile
b) The room free from dust coming from outdoor environment, and put an adhesive mat
c) Humidity from 50% are desirable.
d) Worker should ware conductive shoes, conductive fatigue, conductive glove and
b) To prevent polarizer from scratching, adhesive tape (cellophane tape) should be
c) Pull slowly adhesive tape to peel the laminator off, with spending more than 5 second.
d) The module without laminator should be moved to the next process to prevent
The distance between the blower and the module should
be the best distance of use blower. Also, pay attention to the direction of the module.
stuck at the part of laminator sheet, which is closed to blower. [See the above]
adhesion of dust.
at entrances.
earth wrist band.
Antistatic
Blower
LCD Module
Input CN side
Wind Flow
cellophane
tape
dust, the
LD-20811A -22