GP1UX511QS Sharp Microelectronics, GP1UX511QS Datasheet - Page 3

• Manufacturer Part Number: GP1UX511QS
• Description: IR RECEIVER, 5M, THROUGH HOLE
• Manufacturer: Sharp Microelectronics

Specifications of GP1UX511QS

• Supply Voltage Range: 4.5V To 5.5V
• Operating Temperature Range: -10°C To +70°C
• Length/height, External: 8.8mm
• External Width: 5.5mm
• External Depth: 5.3mm
• Carrier Frequency: 38kHz
• Supply Current: 500µA
• Transmission Distance: 8.5 m
• High Level Pulse Width: 1200 us
• Low Level Pulse Width: 1000 us
• Minimum High Level Output Voltage: 4 V
• Operating Voltage: 4.5 V to 5.5 V
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: - 10 C
• Output Current Max: 1.5mA
• Operating Temperature Max: 70°C
• Rohs Compliant: Yes
• Sensing Distance: 8.5m
• B.p.f. Center Frequency: 38.0kHz
• Voltage - Supply: 4.5 V ~ 5.5 V
• Current - Supply: 600µA
• Orientation: Side View
• Mounting Type: Through Hole
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

■ Performance
1. Linear reception distance characteristics
2.Sensitivity angle reception distance characteristics
3.Anti outer peripheral light reception distance characteristics
Using the transmitter shown in Fig. 1, the output signal of the light detecting unit is good enough to meet the following items in the
standard optical system in Fig. 2.
Fig.1 Transmitter
Fig.2 Standard Optical System
*6 Outer peripheral light source: CIE standard light source A shall be used and placed at 45°from perpendicular axis at the detector face center
*5 It refers to detector face illuminance
When L=0.2 to 8.5m,
When L=0.2 to 4.0m,
When L=0.2 to 6.0m,
However, the PD49PI to be used here should be of the short-circuit current I
(E
In the above figure, the transmitter should be set so that the output V
V
is an illuminance by CIE standard light source A (tungsten lamp).)
*5
*6
*5
E
E
E
V＜
V＜
V≦
10 lx and φ=0°in Fig.2, the output signal shall meet the electrical characteristics in the attached list.
10 lx and φ≦30°in Fig.2, the output signal shall meet the electrical characteristics in the attached list.
300 lx and φ=0°in Fig.2, the output signal shall meet the electrical characteristics in the attached list.
Transmitter
Transmitter (GL521 used)
f
Duty 50%
0
(* 4)
Reception distance:L
20cm
( φindicates horizontal and vertical directions.)
3
Light detector face illuminance:E
10kΩ
Oscilloscope
5V
V
OUT
V
OUT (P-P)
OUT
SC
can be 40mV.
V
=2.6μA at E
V
GP1UX51QS Series
=100 lx.
Sheet No.: OP06012