BTEP-F570VGA-C-TP BATRON, BTEP-F570VGA-C-TP Datasheet - Page 62

• Manufacturer Part Number: BTEP-F570VGA-C-TP
• Description: DISP 5.7" TFT LCD DEV KIT
• Manufacturer: BATRON

Specifications of BTEP-F570VGA-C-TP

• Lcd Display Type: TFT
• Interface Type: RS232, USB
• Viewing Area (h X W): 88mm X 117mm
• Svhc: No SVHC (15-Dec-2010)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

6. Handling Notes
6-1. Precautions
§ This product is intended for use in standard applications (computers, office automation, and other office
6-2. Handling Notes
§ Do not depress or scratch the product with any object with a sharp edge or end.
§ Do not forcibly bend or fold the product.
§ When the product is stored, make sure it is packed in a packing box and stored in a storage temperature
§ Do not use or store the product under a condition where the product will be exposed to water, organic
§ Do not use the product under the direct sunlight.
§ Do not disassemble the product.
§ When you handle the product, Hold the product by its body. Do not hold by the tail.
§ Clean the product with a soft cloth or a soft cloth with neutral detergent or alcohol. When contaminated
§ The edge of the glass is not rounded and may cause injury.
6-3. Construction Notes
§ The environmental specifications, mechanical characteristics, and electrical characteristics are only
§ Do not use the touchscreen when the condensation occurs. The condensation inside of the touchscreen
6-4. Electrical & Software Notice
The best performance can be obtained when used with the original analog resistive touchscreen controller,
“TSC-10” Series. If the touchscreen controller or controller software is to be developed by the customer,
please note the following:
§ There is a contact resistance between the top and bottom electrodes and it changes by the pressure of a
§ The terminal resistance of the analog resistive touchscreen varies by the individual, time, and
§ The analog resistive touchscreen outputs 2 point input as 1 point in between the 2 points. The controller
§ For drawing applications, the line may be intermittent when the pen comes on the dot spacers. A
equipment, industrial, communications, and measurement equipment, personal and household devices,
etc.) Please avoid using this product for special applications where failure or abnormal operation may
directly affect human lives, or cause physical injury or property damage, or where extremely high levels
of reliability are required (such as aerospace systems, vehicle operating control, atomic energy controls,
medical devices for life support, etc.).
range, eliminating any outside load.
solution or acid.
by chemicals, wipe them off immediately with caution not to cause injury to human body.
applied to the Active Area.
is a natural phenomenon and should disappear after the touchscreen is warmed up.
finger or a pen. The data must be read after the contact resistance becomes stabilized.
environment. The controller software must have the calibration function to adjust the input position and
the display position.
software must not be designed to have the 2 point input function.
software compensation is needed.
Data Modul AG - www.data-modul.com
61