860-1R01-002 Dialight, 860-1R01-002 Datasheet - Page 8

• Manufacturer Part Number: 860-1R01-002
• Description: LED OBSTRUCTION LIGHT, 120V, 120mA
• Manufacturer: Dialight
• Type: Continuous/Flashingr

Specifications of 860-1R01-002

• Light Source: LED
• Current Rating: 120mA
• Ip/nema Rating: IP65 / NEMA 4X
• Forward Voltage: 120V
• Brand/series: 860 Series
• Color: Red
• Current, Rating: 120 mA
• Dimensions: 14.14"H
• Enclosure Rating: IP65/IP66
• Ip Rating: IP65/IP66
• Mounting Type: Direct/Conduit
• Primary Type: Beacon
• Size: 147 mm
• Voltage, Supply: 120 VAC

RETRO INSTALLATION STEPS:
► Remove existing lens and clamp from existing fixture
► Do not discard clamp 6 since it will be used to secure light assembly
► Remove and discard all internal components required for use with
► Leave only the source wires that lead into the existing base
► Electrically connect the supply wires to the light assembly wires
► Tuck the connected wires inside the existing base
► Place light assembly on existing base and secure using existing
► Restore power and verify operation
RETRO ONTO 3/4-14 NPT CONDUIT INSTALLATION STEPS:
► Electrically connect the supply wires to the light assembly wires
► Use a 1-1/4” wrench to tighten and attach the light assembly to the conduit
► Restore power and verify operation
RTO-1R07-004
RTO-6R07-004
RTO-1R06-004
RTO-1R08-004
RTO-1R07-004-EU
• same as SINGLE FIXTURE installation
(same as SINGLE FIXTURE installation)
clamp
Please refer to product data sheet for electrical parameters if required
incandescent bulb
Single Retro-FitFixture, European Ver, 120-230 VAC
Single Retro-Fit Fixture, FAA, 120-230 VAC
Single Retro-Fit Fixture, TC, 120-230 VAC
Single Retro-Fit Fixture, FAA, 277 VAC
Single Retro-Fit Fixture, FAA, 12-48 VDC
Dialight reserves the right to make changes at any time in order to supply the best product possible.
http://www.dialight.com/Assets/Brochures_And_Catalogs/Signaling/Obstruction_Brochure.pdf
The most current version of this document will always be available at:
www.dialight.com
Installation of RTO retro-fit version
Obstruction_Brochure_C
Existing
Base
Assembly
Light
Clamp