CRT1-ID16TAH-1 Omron, CRT1-ID16TAH-1 Datasheet - Page 103

• Manufacturer Part Number: CRT1-ID16TAH-1
• Description: 16 In PNP 3 Tier
• Manufacturer: Omron

Specifications of CRT1-ID16TAH-1

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Using Flat Cable I
Connecting Cables and Terminating Resistor
1,2,3...
1,2,3...
Note
■
■
Connection Method
Installation Method
1. Orient the Open Type Connector so that surface with the open terminals is
2. Open the terminal cover of the Open Type Connector and connect the ca-
Before connecting the cable wires to the terminal block, first attach the M3
crimp terminals shown below to the wires.
Attach a DCN4-MD4 Multidrop Connector to the communications connector of
the Slave Unit or Repeater Unit, and then attach two DCN4-BR4 Flat Connec-
tor Plugs that are already connected to Communications Cables.
1. Place the Multidrop Connector so that the surface with the printed number
6.0 mm max.
facing to the left and press in the Open Type Connector until it clicks into
place.
Note To remove a Connector once it has been attached, press in firmly
ble wires to BDH (communications data high) and BDL (communications
data low) in the terminal block. For round cable II, connect the cable wires
to BS+ (communications power supply plus) and BS- (communications
power supply minus).
is facing to the left and press in the Connector until it clicks into place.
on the latches on both sides of the Connector and pull it out.
Slave Unit/Repeater Unit
Multidrop Connector
Communications connector
Flat Connector Plug
6.0 mm max.
Section 3-4
79