TPS101 TIMEGUARD, TPS101 Datasheet - Page 7

• Manufacturer Part Number: TPS101
• Description: SOCKET, WEATHERPROOF, 1GANG, IP55
• Manufacturer: TIMEGUARD

Specifications of TPS101

• Rohs Compliant: NA
• Svhc: No SVHC (15-Dec-2010)

2 Installation
This product must be installed in accordance with the appropriate
Building and Wiring Regulations.
In all cases if there is a doubt as to how to proceed with an
installation consult a qualified electrician, your Local Authority’s
Building Control Department or the Timeguard Helpline
(020 8450 0515).
For the switches the screws holding the case halves together are
located beneath the rocker(s) (front plate switch actuator(s)).
To remove the rocker first press rocker inwards at the blind grommet
end, then, removing hand from there, force fingers as far as possible
between the opposite end of the rocker and the case, pulling the
rocker outwards. The rocker will unclick at it’s pivot point.
If it is not possible to exert enough force by hand, use the
technique shown at the foot of the previous page.
2.1 Cable Entry
Try to avoid siting the units in areas where there is direct sunlight for
any length of time.
Cable entry can be made via conduit into any of the 5 (8 for the
double socket TPS201 and switch socket TP203) knock outs on the
top, bottom, sides or back of the back box. In all cases ensure there
is a drain hole at the lowest point in the attached conduit system.