WPM02 TIMEGUARD, WPM02 Datasheet

WPM02

Manufacturer Part Number

WPM02

Description

CONNECTION BOX, 42 GANG, IP66

Manufacturer

TIMEGUARD

Datasheet

1.WPM02.pdf (2 pages)

Specifications of WPM02

Approval Bodies

BS1363, BS7288 (RCD)

Colour

Light Grey

External Depth

107mm

External Length / Height

230mm

External Width

156mm

Ip/nema Rating

IP66

Operating Temperature Max

40Â°C

Operating

RoHS Compliant

Svhc

No SVHC (15-Dec-2010)

Rohs Compliant

Yes

Current page: 1 of 2
Download datasheet (108Kb)

The WPM02 Minibox is a member of the Weathersafe range which is manufactured from tough, durable thermoplastic, and is

intended for use in an outdoor environment, or one in which the protection provided by the Weathersafe range is required. All of

the products in the range are rated IP65 or better, for protection against water and dust. All Weathersafe products must be fitted

according to the relevant instructions to maintain their IP rating once installed.

This product complies with the following standards:

Introduction

This Weathersafe enclosure is designed to accommodate accessories such as trailing sockets with plugs and transformers that

are pre-wired by the manufacturer.

The product should be mounted on a vertical surface, with cable entries at the bottom and not more than 1.5m above the ground.

There is no earth terminal facility within this enclosure, ensure any accessory requiring an earth is connected via the incoming supply.

The supply should be taken from a power outlet protected by a residual current device (RCD).

Ensure any exposed cable is suitable for use outdoors.

Do not drill holes, apart from those for waterproof cable or conduit entries, into any part of the enclosure as this could impair the

IP66 weatherproof rating.

A knockout for a waterproof 20mm cable gland or conduit entry is provided at the bottom of the box.

Installation

For permanent installation the product should be fastened to the wall using four No. 8, min 1.5in. long wood screws. To aid

installation, a template for the four mounting holes has been provided on the reverse of this instruction leaflet.

Note - installation onto an uneven surface may cause the base to twist and prevent the lid from properly sealing, always check

that the lid is properly located. If it is not, remove the lid, slacken one or more of the four base fixing screws and try again.

For temporary installation the Minibox can be supported on the picture hook located at the top rear centre of the product.

If conduit is to be used there must be sufficient drainage from the lowest points of the conduit, and waterproof cable glands or

conduit entries must be used.

If two cable entry positions are used with metal conduit, then earth continuity between the conduits must be maintained.

If conduit is attached through the side or top surface then the drain hole must be drilled out (see fig 3). Opening this drain hole will

reduce the IP rating of this product.

Purchase the required length of cable to connect the socket strip provided to the supply outlet. Use 3 core 1.5 sq. mm for shorter

lengths or 2.5 sq. mm as an option for longer lengths. These cables are readily available at most DIY sheds.

Connect this cable to the socket strip following the instructions provided on the reverse of this instruction leaflet.

Position socket strip on the velcro fastenings and press down. Plug in output plugs/transformers as required and position their leads

in the waterproof slots as shown in figs 1 and 2.

In the unlikely event of this product becoming faulty due

to defective material or manufacture within 3 years of the

date of purchase, please return it to your supplier in the

first year with proof of purchase and it will be replaced

free of charge. For years 2 and 3 or any difficulty in the

first year telephone the helpline on

WPM02 Weathersafe Instructions

Top

3 Year Guarantee

Fig. 1

020 8450 0515.

Top

IP66 rating: BS EN 60529

67.058.???

Specifications for the enclosure.

Degree of protection

Maximum cable size

Operating temperature range

Installation temperature range

Timeguard Ltd. Victory Park, 400 Edgware Road,

Fig. 2

London NW2 6ND Tel: 020-8452-1112

For a product brochure please contact:

or email csc@timeguard.com

Socket outlets: BS 1363

Top

IP66

2.5 sq. mm, 3core

-20° to 40°C

0° to 40°C

Drain

Fig. 3

Related parts for WPM02

WPM02 Summary of contents

Page 1

... WPM02 Weathersafe Instructions The WPM02 Minibox is a member of the Weathersafe range which is manufactured from tough, durable thermoplastic, and is intended for use in an outdoor environment, or one in which the protection provided by the Weathersafe range is required. All of the products in the range are rated IP65 or better, for protection against water and dust. All Weathersafe products must be fitted according to the relevant instructions to maintain their IP rating once installed ...

Page 2

... Drill Here Base Mounting Remove velcro to reveal socket terminal cover screws. Drill Here WPM02_Instructions.indd 2 WPM02_Instructions.indd 2 134 THIS WAY UP Template Wiring Instructions 6mm N Blue 6mm stripped stripped 25mm L Brown E Green/Yellow 25mm 25mm Drill Here 117 Drill Here 189 10/5/07 5:21:54 pm 10/5/07 5:21:54 pm ...

Related keywords

WPM02 datasheet
WPM02 data sheet
WPM02 pdf datasheet
WPM02 component
WPM02 part
WPM02 distributor
WPM02 RoHS
WPM02 datasheet download