EVK-CONNECT-013 DENSITRON, EVK-CONNECT-013 Datasheet - Page 5

• Manufacturer Part Number: EVK-CONNECT-013
• Description: CONNECTION BOARD, FOR 1498838, EVK
• Manufacturer: DENSITRON

Specifications of EVK-CONNECT-013

• Svhc: No SVHC (18-Jun-2010)
• Rohs Compliant: YES
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

2 Symbol Definition
VCC : Power supply for panel driving voltage.
VSS：This is ground pin.
VDD：Power supply for core logic operation.
VDDIO：Power supply for interface logic level.
BS0~BS2：MUC bus interface selection pin(BS0 pulled LOW in internal).
CS：This pin is chip select input(active LOW).
RES：This pin is reset signal input(active LOW).
D/C：This is DATA/COMMAND control pin. When it is Pulled HIGH, the data at D[0~7] is
treated as data. When it is pulled LOW, the data at D[0~7] will be transferred to the command
register.
R/W：This is read/write control input pin connecting to the MCU interface.
interface to a 6800-series microprocessor , Read mode will be carried out when this pin is
pulled HIGH and write mode when low .
pin when be the data Write input.
connected to Vss.
E/RD：When interface to a 6800-series microprocessor , this pin will be used as the
Enable(E) signal.
Read(RD#)signal.
D0~D7：These are 8-bit bi-directional data bus to be connected to the microprocessor’s data
bus. When serial interface mode is selected, D0(SCLK) will be the serial clock
input,D1(SDIN) will be the serial data input,D2 should be left opened. When I2C mode is
selected,D1(SDAin) AND D2(SDAout) should be tied together,D0(SCL) is the I2Cclock
input
IREF：This is segment output current reference pin.
VCOMH：This pin for COM signal deselected level voltage.
Product No.
Copyright ©2007 DENSITRON TECHNOLOGIES plc. All rights reserved. – Proprietary Data
In I2C mode, this pin acts as SA0 for slave address select.
When interface to an 8080-microprocessor , this pin receives the
DD-6448BE-2A
When serial interface is selected, this pin must be
When interface to an 8080-microprocessor , this
REV. A
Page
When
5 / 16