SK-FR80-120PMC-USB Fujitsu, SK-FR80-120PMC-USB Datasheet - Page 125

• Manufacturer Part Number: SK-FR80-120PMC-USB
• Description: BOARD, EVAL, FOR MB91660 SERIES
• Manufacturer: Fujitsu
• Type: Evaluation Boardr

Specifications of SK-FR80-120PMC-USB

• Kit Features: External FRAM Memory MB85RS256, USB A & USB A Connectors, USB To Serial Converter
• Mcu Supported Families: MB91660
• Silicon Manufacturer: Fujitsu
• Core Architecture: FR80
• Kit Contents: Board, USB A To Mini-B Cable
• Features: USB Connector, 7-segment LED, Humidity Sensor
• Rohs Compliant: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

speed of 32 MHz.
not delete these definitions.
(3) FshLdWrt.prc /
FLASH memory.
(FLASH write command) programs.
"sample_skeleton" project. (Note, the DATA_SIZE (*1) must be changed if the data size exceeds,
0x00004000.)
(All lines after the # are treated as comments.)
#-----------------------------------------------------------------------
set variable WRITE_SIZE
set variable DATA_SIZE
set variable WRITE_ADR
#Write data
set variable DATA_FILE
(*2)
(- omitted -)
= load/debug
#-----------------------------------------------------------------------
The monitor program is designed to allow communications with the PC at a peripheral clock
_fr.h defines the I/O registers for MB91F662.
mon.h is required to use the monitor program.
Files with the .prc extension are referred to as "procedure files (or batch files)".
These files can be invoked as "commands" while SOFTUNE is running.
FshLdWrt.prc is the command file for writing files created in SOFTUNE to the MB91F662
This file executes the flash_erase_sec.bin (FLASH sector erase command) and flash_write.bin
Two header files are defined at the beginning of the program.
(For details, refer to "ioregj.txt" in the sample program folder "IOH_MB91660_V01L02".)
Interrupt vector definitions used by the monitor program are defined at the end of main.c. Do
This file can be used without any modification for programs created using the
If you create a new workspace or project, the code indicated in italics (red) must be edited.
(*1) Must be changed if the data size exceeds, 0x00004000.
(*2) Change to name of program you are creating.
Debug¥ABS¥sample_skeleton.abs
flash_write.bin /
= 0x00008000
=
= 0x00080000
=
0x00004000
Debug¥ABS¥sample_skeleton.bin
flash_erase_sec.bin
124
# Data size to be written to FLASH
#data size to initialize in FLASH (*1)
#Starting address in FLASH memory to write to
(Erases the sector that includes this range.)
#Specify using relative path (*2)
#Specify using relative path