SK-16FX-EUROSCOPE Fujitsu, SK-16FX-EUROSCOPE Datasheet - Page 9

• Manufacturer Part Number: SK-16FX-EUROSCOPE
• Description: Low Cost Fujitsu 16FX Evaluation Board
• Manufacturer: Fujitsu

Specifications of SK-16FX-EUROSCOPE

• Silicon Manufacturer: Fujitsu
• Features: 576 Kbyte Flash Memory, LIN-USART Interfaces, External Interrupts
• Kit Contents: SK-16FX-100PMC Board, Mini CD, USB Cable, RS232 Cable
• Silicon Core Number: MB96340
• Rohs Compliant: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Fujitsu Microelectronics Europe - http://emea.fujitsu.com/microelectronics
The Hardware
S1: Mode selection
PROG:
RUN:
JP3: DTR-Reset
Set the jumper to 1-2 to connect
the DTR-Signal
of the UART connector to the
microcontroller reset-pin.
Set the jumper to 2-3 to connect
the DTR-Signal
of the USB connector to the
microcontroller reset-pin.
Some terminal-programs, e.g.
Fujitsu‘s Skwizard, allow to reset
the evaluation board by using the
DTR-Signal.
JP6: MD0 selection
Close this jumper to control the
MD0 level by the RTS signal of the
USB interface
The jumpers
Select the run-mode
Select the program-mode
JP4: UART RX select
R-0: UART0=UART‘A‘ / U-1: UART1=UART‘B‘ (USB)
R-1: UART1=UART‘A‘ / U-0: UART0=UART‘B‘ (USB)
JP9: MCU Vcc
This jumper can be used to measure
the current consumption of the MCU
JP10: 5V / 3.3V
1-2: 5V supply is used
2-3: 3.3V supply is used
JP5: UART TX select
R-0: UART0=UART‘A‘ / U-1: UART1=UART‘B‘ (USB)
R-1: UART1=UART‘A‘ / U-0: UART0=UART‘B‘ (USB)
All Rights Reserved.© Fujitsu Limited 2007
JP11: Power Supply
1-2: USB supply is used
2-3: External supply is used
9