4799 3M, 4799 Datasheet - Page 2

• Manufacturer Part Number: 4799
• Description: ADHESIVE, TUBE, 5OZ
• Manufacturer: 3M

Specifications of 4799

• Color: Black
• Dispensing Method: Tube
• Weight: 5oz
• Features: Brushable, Heat Resistant Adhesive That Develops Strength Rapidly And Provides Good Creep Resistance And Low Soak-in On Porous Surfaces
• For Use With: Bond Rubber (including EPDM) And Many Materials Such As Canvas And Linoleum To Metal, Wood And Concrete

Handling/Application
Information
3M
Industrial Adhesive
4799
Application Equipment
Suggestions
Typical Adhesive
Performance
Characteristics
™
Scotch-Weld
Directions for Use
1. Surface Preparation: Surfaces to be bonded must be clean, dry and dust free.
2. Application Temperature: For best results the temperature of the adhesive and
3. Application: Stir or agitate well before using.
4. Cleanup: Excess adhesive may be removed with a solvent such as methyl ethyl
*Note: When using solvents, extinguish all sources of ignition in the area and
Note: Appropriate application equipment can enhance adhesive performance. The
1. Pumping: Use a 5:1 ratio double acting, ball check pump with a 3 inch diameter
2. Hoses: Material hoses should be nylon lined with a working pressure of 500 psi or
3. Brushes: Brushes designed for use with oil based paint may be used.
Note: The following technical information and data should be considered representative
Wiping with a solvent such as methyl ethyl ketone (MEK)* will aid in removing
oil and dirt.
the surfaces being bonded must be at least 65°F (18°C).
ketone (MEK).*
air motor. All packings and glands in contact with the adhesive should be PTFE
coated.
greater.
™
or typical only and should not be used for specification purposes.
user is responsible for evaluating application equipment in light of the user’s
particular purpose and method of application.
@ 75°F (24°C)
Porous Surface(s): Brush a uniform, generous coat of adhesive on the least
porous surface to be bonded. Assemble the materials immediately with
sufficient pressure to ensure contact.
Non-Porous Surface(s): Apply a uniform coat of adhesive to each surface.
Allow adhesive to dry until it is tacky, but does not transfer. Assemble
materials with sufficient pressure to ensure contact.
follow the manufacturer’s precautions and directions for use when handling
such materials.
after 3 wk.
after 3 wk.
after 3 wk.
3 days
5 days
7 days
Time
1 day
2 wk.
3 wk.
180° PEEL STRENGTH – Canvas/Steel
- 2 -
150°F (66°C)
180°F (82°C)
-30°F (-34°C)
75°F (24°C)
75°F (24°C)
75°F (24°C)
75°F (24°C)
75°F (24°C)
75°F (24°C)
Temp.
Test
(lbs./in. width)
Value
15.5
22
25
25.5
27.5
28
14
8.5
5