LINKMATIK RF Solutions, LINKMATIK Datasheet - Page 6

• Manufacturer Part Number: LINKMATIK
• Description: TRANSCEIVER, LINKMATIK, 18PIN, DIL
• Manufacturer: RF Solutions

Specifications of LINKMATIK

• Svhc: No SVHC (15-Dec-2010)

The PIN code may be up to 16 characters long.
Note that many mobile phones can only specify
the digits 0-9 as PIN codes.
Wedded Pairs
To create a wedded pair, one device must be the
master and the other the slave. Set the same PIN
code on both devices. Then place the first device
in Auto-Slave mode.
Place the second device in Auto-Master mode. It
will have nothing paired with it initially. To set up
its pair, use the I command to scan for the slave
device.
Example:
Response example:
When the inquiry command is complete, connect
to the Auto-Slave device using the C command,
referring to the Bluetooth address reported in the
INQUIRY response obtained during the scan.
Format:
Example:
Response:
The devices will now be paired.
devices power up, they will connect together
automatically
Command Mode
To configure LinkMatik for Command / Data mode,
send the following commands:
Migration from LinkMatik 1.0
Migration from LinkMatik 1.0 should be relatively
straightforward.
considered:
Page 6
• The MSM pin is replaced with the ESC pin
• ATN pin performs the same function as the
INQUIRY_PARTIAL 01:23:45:67:89:AB DEVCLS
INQUIRY 1
INQUIRY BTADDR DEVCLS ““ RSSI
NAME BTADDR DEVNAME
which should be kept low except to switch to
command mode.
earlier Status pin outputting high when the
device is connected.
SET CONTROL AUTOCALL
SET CONTROL ECHO 4
SET CONTROL CD 4 1
SET BT PAGEMODE 3 2000 1
7-Jul-06
I 8 N
C BTADDR 1101 RFC
C 01:23:45:67:89:AB 1101 RFC
CALL LINKID
CONNECT LINKID RFCOMM
The following issues must be
LinkMatik 2.0 DS379-1
When both
© FlexiPanel Ltd
Migration from BlueMatik 1.0
Migration from BlueMatik 1.0 is possible but will
require modification of the motherboard and host
firmware.
considered:
• Data should not be sent to LinkMatik when
• Connect / Sleep pin is no longer functional.
• Auto-Master Mode connects according to its
• Pin-out substantially changed
• Command set substantially changed.
ATN is low; it will be interpreted as a
command
Sleep mode can only be entered from
command mode.
list of paired devices rather than the name of
the remote device.
Patents apply and/or pending
The
following
issues
www.FlexiPanel.com
must
be