BTM402-03 Laird Technologies, BTM402-03 Datasheet - Page 26

• Manufacturer Part Number: BTM402-03
• Description: MODULE, BLUETOOTH, BISM2 PA, 3.6V
• Manufacturer: Laird Technologies

Specifications of BTM402-03

• Compliance Standard: CE, FCC, IC, R, TTE
• Supply Voltage Range: 3.3V To 5V
• Physical Interfaces: UART
• Data Rate: 300Kbps
• Transmit Power: 65mW
• Receiving Signal Range: -87dBm
• Operating Temperature: RoHS Compliant
• Operating Temperature Range: -10°C To +85°C
• Rohs Compliant: Yes

Designers should note the distinction that the FCC makes regarding portable and mobile devices.
Mobile devices are defined as products that are not used closer than 20cm to the human body,
whereas portable devices can be used closer that 20cm to the body. In the case where the WISM
module is used in a portable device, additional SAR testing must be performed on the complete
product.
12.3.2.1
If the FCC ID is not visible when the module is installed inside another device, then the outside of the
device into which the module is installed must also display a label referring to the enclosed module.
This exterior label can use wording such as the following: “Contains Transmitter Module FCC ID:
PI409B” or “Contains FCC ID: PI409B.” Any similar wording that expresses the same meaning may be
used.
12.3.3
A list of the countries where the Module is approved will be provided by EZURiO as required. As a
minimum the product is listed in Europe, Scandinavia, Canada and USA. EZURiO assumes no liability
for customer failure to comply with national RF approval.
12.3.3.1
The 2.4GHz band has some restrictions within the EU when the transmit power level is greater than
10mW (R&TTE Class 2). Because of this, it is designated within R&TTE as a non-harmonised band.
Such products must be notified to the appropriate Notified Body within each country where it is
placed on the market.
within their products and intending to sell these within Europe have a responsibility to notify the
appropriate nominated body before commercial introduction. A list of nominated bodies is available
at:
http://eur-lex.europa.eu/LexUriServ/site/en/oj/2003/c_302/c_30220031212en00010414.pdf
Further details on the notification procedure are given in EZURiO’s Application Note AN016 -
Notification Requirements for Wireless Products.
DSH_BTM404_0v5 BISM2 3V3 PA Data Sheet.DOC
National RF approvals
FCC Labelling requirement
R&TTE Notification Requirement
EZURiO has notified the WISM module, but manufacturers incorporating it
26
© 2007-8 EZURiO Ltd
www.EZURiO.com