192990-2650 ITT Cannon, 192990-2650 Datasheet - Page 77

• Manufacturer Part Number: 192990-2650
• Description: Connector Contact,PIN,CRIMP Terminal
• Manufacturer: ITT Cannon

Specifications of 192990-2650

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Cannon Trident Connectors
www.ittcannon.com
Dimensions shown in mm (inch)
Specifications and dimensions subject to change
Contact Insertion
No insertion tool is required. Trident
contacts are inserted from the rear of the
connector and held in place by retention
tines (cantilever springs). These tines
compress during insertion. They expand
once contact is in place and prevent the
contact from backing out.
Trident Assembly
Instructions
TNM Assembly, see page 78)
Assembly instructions:
1. Grasp the crimped or soldered contact
just behind where the wire enters the
contact.
2. Push the contact into the connector
cavity until it locks into place.
3. Pull on the wire slightly to verify that
the contact is secure.
4. Inspect the mating face of the
connector. The contacts should extend
the same distance into the connector.
Contact Retention Forces
•
Minimum retention force of the
contact to the insulator.
(For Neptune and
Note: Newton is a metric unit of force. One pound = 4.45 Newtons
Proper Insertion of Trident Contact
Contact Insertion - Slimline
(Formed Crimp, Machined Crimp,
Solder Cup, Flow Solder)
30 A Power Contacts
Coaxial Contacts
Signal Contacts
77
Contact
RETENTION TINE
Contact Insertion - Ringlock
Assembly Instructions
Newton(s)
100
67
67