B45196E3105K109 Kemet, B45196E3105K109 Datasheet - Page 5

• Manufacturer Part Number: B45196E3105K109
• Description: CAPACITOR, 1.0UF 16V RL 2000CAPACITOR, 1.0UF 16V RL 2000
• Manufacturer: Kemet
• Series: B45196Er

Specifications of B45196E3105K109

• Capacitance: 1UF
• Voltage Rating, Dc: 16V
• Capacitor Dielectric Type: TANTALUM ELECTROLYTIC
• Tolerance,: 10%
• Tolerance, -: 10%
• Temp, Op. Min: -55(DEGREE C)
• Rohs Compliant: YES
• Voltage Rating: 16 Volts
• Tolerance: 10 %
• Operating Temperature Range: - 55 C to + 125 C
• Package / Case: 1206 (3216-18 metric)
• Product: Tantalum Solid High Temperature
• Dissipation Factor Df: 4
• Leakage Current: 0.5 uAmp
• Termination Style: SMD/SMT
• Lead Free Status / Rohs Status: Details

Low-resistance applications and voltage networks
For low-resistance applications, EPCOS recommends a maximum operating voltage of half the
permissible maximum continuous voltage, so that the capacitors have sufficient tolerance to
withstand voltage peaks. Depending on the conditions of use, the early failure rate is higher here
by a factor of 2 to 20 than in the range with a constant failure rate as specified in the data book
(see“Quality and environment”, section 1.11 under www.epcos.com/tantalum_capacitors).
When operated directly in a voltage network, the capacitor should be protected against
overvoltage, e.g. by a suppressor diode, and against polarity reversal by a diode. If a capacitor is
operated in an unprotected low-impedance circuit and fails because the permissible conditions for
the forward DC voltage, reverse DC voltage, surge current, power dissipation or temperature are
exceeded, the continued current flow through the overstressed capacitor may produce
overheating. The overheated capacitor may damage the surrounding components and the circuit
board (see“Quality and environment”, section 1.11 and “General technical information”, section
4.11 under www.epcos.com/tantalum_capacitors).
Storage conditions
Capacitors with solid electrolyte may be stored at temperatures down to –80 C. The upper
storage temperature must not exceed +85 C (for blister tape the temperature limit is +40 C).
The storage conditions should not exceed +40 C and 70% R. H. A drypack is useful to prevent
the effects of humidity.
Note
For more detailed information about cautions and warnings for tantalum electrolytic capacitors
(e.g. other electrical values beside those listed above),see “General technical information” and
“Quality and environment” under www.epcos.com/tantalum_capacitors.
Please read Cautions and warnings and
Important notes at the end of this document.
Tantalum chip capacitors
Standard / HighCap
Page 5 of 6
B45196E3105+10*