ERJT08J272V Panasonic, ERJT08J272V Datasheet - Page 9

• Manufacturer Part Number: ERJT08J272V
• Description: RESISTOR, ANTI PULSE, 1206, 2K7, 5%
• Manufacturer: Panasonic

Specifications of ERJT08J272V

• Rohs Compliant: YES

Subject
Part No.
11. Storage Method
12. Laws and Regulations
13. Production site
Chip Resistor
If the product is stored in the following environments and conditions, the performance and
solderability may be badly affected, avoid the storage in the following environments.
(1) Storage in places full of corrosive gases such as sea breeze, Cl
(2) Storage in places exposed to direct sunlight.
(3) Storage in places outside the temperature range of 5 deg.C to 35 deg.C and humidity
(4) Storage over a year after our delivery (This item also applies to the case where the storage
(1) This product has not been manufactured with any ozone-depleting chemical controlled under
(2) This product complies with the RoHS Directive (Restriction of the use of certain Hazardous
(3) All materials used in this part are registered material under the Law Concerning the
(4) All the materials used in this part contain no brominated materials of PBBO
(5) If you need the notice by letter of “A preliminary judgement on the Laws of Japan foreign
(7) Halogen type (Chlorine type, Bromine type, etc.) or other high-activity flux is not
(8) When soldering with soldering iron, never touch the body of the chip resistor with a tip of
(9) Avoid physical shock to the resistor and nipping of the resistor with hard tool (a pair of
(10) Avoid immersion of chip resistor in solvent for long time. Use solvent after the effect of
Country : Japan
Plant : Panasonic Electronic Devices Fukui Co., Ltd.
flame-retardant.
exchange and Foreign Trade control”, be sure to let us know.
range of 45 %RH to 85 %RH.
method specified in item (1) to (3) has been followed.).
the Montreal Protocol.
Substances in electrical and electronic equipment (DIRECTIVE 2002/95/EC)).
Examination and Regulation of Manufacturs, etc. of Chemical substances.
recommended as the residue may affect performance or reliability of resistors.
the soldering iron. When using a soldering iron with a tip at high temperature, solder for a
time as short as possible. (three seconds or less up to 350 deg.C)
pliers or tweezers) as it may damage protective film or the body of resistor and may affect
resistor’s performance.
immersion is confirmed.
PRODUCT SPECIFICATION FOR IMFORMATION
Panasonic Electronic Devices Co., Ltd.
ERJT08
2
, H
2
S, NH
3
Spec. No.
S
151-SRJ-ET0801A
, SO
or PBB
2
11
, and NO
-
S
8
as the
X
.