LQ035Q7DH07 Sharp Microelectronics, LQ035Q7DH07 Datasheet - Page 18

• Manufacturer Part Number: LQ035Q7DH07
• Description: TFT Displays & Accessories 3.5 TFT QVGA 240x320 225 nit
• Manufacturer: Sharp Microelectronics

Specifications of LQ035Q7DH07

• Product: Displays
• Pixel Density: 240 x 320
• Module Size (w X H X T): 65 mm x 86.2 mm x 3.2 mm
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

(10) Display quality
(11) Mechanical characteristics
(12) Handling Precautions
11-1) External appearance
11-2) FPC (for LCD panel) characteristics
12-1) Insertion and taking out of FPCs
12-2) Handling of FPCs
12-3) Installation of the module
12-4) Precautions when mounting
12-5) Others
The display quality of the color TFT-LCD module shall be in compliance with the Incoming Inspection Standards for TFT-LCD.
(1) If water droplets and oil attaches to it for a long time, discoloration and staining occurs. Wipe them off immediately.
(2) Glass is used for the TFT-LCD panel. If it is dropped or bumped against a hard object, it may be broken. Handle it with
(1) The liquid-crystal is deteriorated by ultraviolet rays. Do not leave it in direct sunlight and strong ultraviolet rays for
(2) If it is kept at a temperature below the rated storage temperature, it becomes coagulated and the panel may be broken.
(3) If the LCD breaks, don’t put internal liquid crystal into the mouth. When the liquid crystal sticks to the hands, feet and
(4) Wipe off water drop or finger grease immediately. Long contact with water may cause discoloration or spots.
(5) Observe general precautions for all electronic components.
(6) VCOM must be adjusted on condition of your final product. No adjustment causes the deterioration for display quality.
(7) Static image should not be displayed more than 5 minutes in order to prevent from occurrence of residual image.
(3) As the CMOS IC is used in this module, pay attention to static electricity when handling it. Take a measure for grounding
Be sure insert and take out of the FPC into the connector of the set after turning off the power supply on the set side.
The FPC for LCD panel shall be bent only slit portion. The bending slit shall be bent uniformly on the whole slit portion
with bending radius larger than 0.6mm, and only inner side (back side of the module). Don’t bend it outer side (display
surface side).
Don’t give the FPCs too large force, for example, hanging the module with holding FPC.
On mounting the module, be sure to fix the module on the same plane. Taking care not to warp or twist the module.
See Fig. 1
(1)Specific connector
(2) Bending endurance of the bending slits portion
sufficient care.
many hours.
Also, if it is kept at a temperature above the rated storage temperature, it becomes isotropic liquid and does not return to
its original state. Therefore, it is desirable to keep it at room temperature as much as possible.
clothes, wash it out immediately.
on the human body.
FH12A-50S-0.5SH(55) or FH12-50S-0.5SH(55) (HIROSE)
No line of the FPC is broken for the bending test (Bending radius=0.6mm and angle=90°) in 30 cycles.
LCP-06012-15