93-22SURSYGC/S530-A2/TR8 Everlight Electronics CO., LTD, 93-22SURSYGC/S530-A2/TR8 Datasheet - Page 10

• Manufacturer Part Number: 93-22SURSYGC/S530-A2/TR8
• Description: Standard LED - SMD Red/Yellow-Green
• Manufacturer: Everlight Electronics CO., LTD

Specifications of 93-22SURSYGC/S530-A2/TR8

• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Precautions For Use
1. Over-current-proof
2. Storage
3. Soldering Condition
3.2 Reflow soldering should not be done more than two times.
3.3 When soldering, do not put stress on the LEDs during heating.
3.4 After soldering, do not warp the circuit board.
4.Soldering Iron
seconds within once in less than the soldering iron capacity 25W. Leave two seconds and more
intervals, and do soldering of each terminal. Be careful because the damage of the product is often
started at the time of the hand solder.
2.1 Do not open moisture proof bag before the products are ready to use.
2.2 Before opening the package: The LEDs should be kept at 30℃ or less and 90%RH or less.
2.3 After opening the package: The LED's floor life is 1 year under 30 deg C or less and 60% RH or less.
2.4 If the moisture absorbent material (silica gel) has faded away or the LEDs have exceeded the
Everlight Electronics Co., Ltd.
Device No. : DSE-932-027
Customer must apply resistors for protection, otherwise slight voltage shift will cause big
current change ( Burn out will happen ).
3.1 Pb-free solder temperature profile
If unused LEDs remain, it should be stored in moisture proof packages.
storage time, baking treatment should be performed using the following conditions.
Baking treatment : 60±5℃ for 24 hours.
Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3
EVERLIGHT ELECTRONICS CO.,LTD.
http://www.everlight.com
prepared date: 21-Sep-2005
93-22SURSYGC/S530-A2/TR8
Rev. 2
Prepared by: Ray Yuan
Page: 10 of 11