CAT-HT-179-2630-01 Samtec Inc, CAT-HT-179-2630-01 Datasheet - Page 3

• Manufacturer Part Number: CAT-HT-179-2630-01
• Manufacturer: Samtec Inc
• Type: Toolr

Specifications of CAT-HT-179-2630-01

• Lead Free Status / RoHS Status: Supplier Unconfirmed

MINI-POWER CONNECTOR
IPD1 SERIES (CC79-X)
STEP 3
- Partially close the tool to hold the terminal in place (up to one ratchet click).
- Insert the wire into terminal until the end of the insulation is against the stop.
- Close handles until the ratchet releases.
- Open handles fully so that the insulation stop can eject the terminal from crimpers.
- Remove the completed termination.
MAINTENANCE
- Keep tool free of dust, moisture and other contaminants using a clean brush or lint free cloth.
- Make sure that the retaining pins are in place and that they are secured with retaining rings.
- All pivot pins and sliding surfaces should be provided with a thin coat of SAE No. 20 oil. Keep
- When the tool is not in use, keep handles closed to prevent objects from becoming lodged in
MIS-CRIMPS AND JAMS
If the tool becomes jammed in the partially closed position, do not attempt to force the handles
open or closed. The tool can be opened easily by releasing the ratchet paw between the handles.
NOTES:
- Samtec does not repair hand tools. If the tooling becomes damaged or worn, a new tool must
- This tool is not adjustable for crimp height and is intended for standard conductor sizes. It may
- Pull force should be used as the final criteria for an acceptable crimp. A complete evaluation
- This hand tool is intended for low volume, prototyping or repair only. Repetitive use of this
Samtec Quality Assurance Department
This is a controlled document and is subject to change (printed versions are not controlled)
tool should be avoided.
oil out of crimp tools.
the crimp tooling. Store the tool in a clean, dry area.
be purchased.
for crimp quality can be found in Application Specification STS-A-001.
not give a good insulation support crimp for all insulation sizes.
HAND CRIMPING TOOL
CAT-HT-179-2024-01
CAT-HT-179-2630-01
Page 3 of 3
Rev. Date: 7/7/2005
STS-M-002
INSTRUCTION
SHEET
Rev. C