4381-5PG-300 Switchcraft Inc., 4381-5PG-300 Datasheet - Page 35

• Manufacturer Part Number: 4381-5PG-300
• Manufacturer: Switchcraft Inc.
• Type: Field Installabler

Specifications of 4381-5PG-300

• Contact Gender: PIN
• Number Of Contacts: 5POS
• Mounting Style: Panel
• Termination Method: Solder
• Contact Plating: Gold Over Nickel
• Body Orientation: Straight
• Strain Relief: No
• Contact Material: Brass
• Contact Classification: 5Signal
• Operating Temp Range: -55C to 125C
• Product Diameter (mm): 29.3mm
• Product Depth (mm): 25.4mm
• Product Height (mm): 29.3mm
• Lead Free Status / RoHS Status: Compliant

Contact Insertion/Removal Tools
Pneumatic Crimping Tools - Consult Factory
Manual Contact Crimping Tools
Contact Crimping and Assembly Procedures:
A. Push cable through connector components, i.e. backshell, grommet, sleeve, and coupling ring.
B. Wire preparation: Strip cable to dimensions shown. Make all cuts square and sharp being careful not to nick wires
C. Contact crimping tools, use as follows:
D. Contact insertion tools. Place wired contact into proper connectors cavity. Guide tip of the insertion tool so that it starts
when cutting. To prevent stranded wires from fraying it is recommended that ends be tightly twisted and not solder
dipped.
at the contact and slides down against the stop. Apply a steady force perpendicular to the contact until it snaps into
position.
Assemble contact locator to tool.
Check tool setting for wire gage to be crimped.
Drop contacts, mating end first into locator so that it rests fully on bottom. Insert stripped lead into contact barrel
until it stops.
Close tool handles completely in one stroke. (The ratchet will not release jaws until tool has completed cycle.)
Inspect crimp to be sure there are no loose strands outside the contact which may short out to an adjacent contact.
®
®
Conductor Strip Lengths
601 East Wildwood, Villa Park, Illinois 60181 • Telephone [phone] • Fax [phone] • www.conxall.com
#20 -3/16
#16 -7/32
#12 -7/32
CON-X
#16 -9/32
#12 -7/32
MIL-E-QUAL
T
OOLING
35
Cable Stripping
Product not designed to
remove contacts after
insertion. Consult factory
for removal tools.