1648317-1 TE Connectivity, 1648317-1 Datasheet - Page 12

• Manufacturer Part Number: 1648317-1
• Description: 702-31-01107=CONTACT,SKT,#8
• Manufacturer: TE Connectivity
• Type: Contactr
• Series: ELCONr

Specifications of 1648317-1

• Gender: SKT
• Body Orientation: Straight
• Housing Material: Not Required
• Number Of Contacts: 1POS
• Number Of Ports: 1Port
• Number Of Terminals: 1
• Pitch (mm): Not Requiredmm
• Contact Material: Copper Alloy
• Mounting Style: Cable
• Termination Method: Crimp
• Contact Plating: Silver
• Pin Or Socket: Socket
• Contact Termination: Crimp
• Wire Gauge: -
• Contact Finish: -
• Contact Finish Thickness: -
• Current Rating: -
• Lead Free Status / RoHS Status: Not Compliant

GIncludes hot plug contacts
3.12. Connector Seating
The connector standoffs must be seated on the pc board or panel not exceeding the dimension shown in
Figure 10.
3.13. Soldering
Observe guidelines and procedures when soldering contacts is required. All solder joints should conform to
those specified in Workmanship Specification IPC--A--610 and all other requirements specified in this
document. Contacts must be stabilized during soldering with a non--metallic material. Solder, clean, and dry all
wire leads to contacts according to the following:
12 of 17
NOTE
Finished Hole Diameter
After Plating (Refer to Table)
E. PC Board Hole Dimensions
The solder type contacts may be used with or without plated through holes. If plated, the drilled hole size,
plating types, and plating thickness are dependent on the application requirements. The finished hole size
must be as stated to provide unrestricted insertion and ensure adequate application of solder to the solder
tines. See Figure 9.
i
Drilled Hole Diameter
(As Required)
Hold- - downs may be used to ensure stability during the soldering procedure.
Connector
CONTACT SIZE
12G
20
16
8
PC Board (Ref)
Copper Plating (Ref)
(Max Hardness 150 Knoop)
Tin- - Lead Plating (Ref)
Tyco Electronics Corporation
0.51
[.020]
Figure 10
Figure 9
Trace Width (As Required)
Pad Width (As Required)
0.51
[.020]
FINISHED HOLE DIAMETER (+0.08 [+.003])
Plating Recommendations:
Standoffs
Tin Plate 0.005 mm [.0002 in.] Min. Thick
Over Copper 0.025 mm [.0010 in.] Thick
1.20 [.047]
1.80 [.070]
2.65 [.104]
3.82 [.152]
Wire
Rev D