CDBLB455KCAY09-B0 Murata, CDBLB455KCAY09-B0 Datasheet - Page 72
![no-image](/images/manufacturer_photos/0/4/464/murata_sml.jpg)
CDBLB455KCAY09-B0
Manufacturer Part Number
CDBLB455KCAY09-B0
Description
Signal Conditioning CDBLB455KCAY09-B0
Manufacturer
Murata
Datasheet
1.CDBLB455KCAY09-B0.pdf
(76 pages)
Specifications of CDBLB455KCAY09-B0
Rad Hardened
No
Product
Ceramic Filters
Operating Temperature Range
- 20 C to + 80 C
Lead Free Status / RoHS Status
Compliant
!Note
• This PDF catalog is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our
• This PDF catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
sales representatives or product engineers before ordering.
!Note
1. Standard Reflow Soldering Conditions
(1) Reflow
(2) Soldering Iron
2. Wash
1. The component will be damaged when an excessive
2. In the case that the component is cleaned, confirm
3. In case of covering discriminator with over coat,
4. Do not use strong acidity flux, more than 0.2wt%
1. Do not use this product with bend. The component
2. The component will be damaged when an excessive
3. All kinds of re-flow soldering must not be applied
4. Do not clean or wash the component as it is not
stress is applied.
no reliability degradation is created.
conditions such as material of resin, cure
temperature, and so on should be evaluated
carefully.
chlorine content, in re-flow soldering.
may be damaged if excess mechanical stress is
applied to it mounted on the printed circuit board.
stress is applied.
on the component.
hermetically sealed.
CDSCB Series Notice (Soldering and Mounting)
CDBKB Series Notice (Handling)
CDBLA/CDBLB Series Notice (Handling)
Filter is soldered twice within the following temperature
conditions.
Filter is soldered at +300 5 C for 3.0 0.5 seconds. The
soldering iron should not touch the filter while soldering.
The component cannot withstand washing.
Continued from the preceding page.
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
5. The product, packed in the moisture-proof bag (dry
5. Do not use strong acidity flux, more than 0.2wt%
6. In case of covering discriminator with over coat,
pack), is sensitive to moisture.
The following treatment is required before
applying re-flow soldering, to avoid package
cracks or reliability degradation caused by
thermal stress. When unpacked, store the component
in an atmosphere of below 25 degree C. and below
65%R.H., and solder within 48 hours.
chlorine content, in flow soldering.
conditions such as material of resin, cure
temperature, and so on should be evaluated
carefully.
260
230
100
Ceramic Discriminators Notice
30 sec.
min.
(150-180 C)
Pre-heating
60-120 sec.
(260 C max.)
Heating
(230 C)
40 sec.
Peak
max.
Gradual
Cooling
120 sec.
min.
71
P05E.pdf
06.2.13
19