CFWLB455KF1Y-B0 Murata, CFWLB455KF1Y-B0 Datasheet - Page 49

• Manufacturer Part Number: CFWLB455KF1Y-B0
• Description: Signal Conditioning CFWLB455KF1Y-B0
• Manufacturer: Murata
• Type: Ceramic Filterr

Specifications of CFWLB455KF1Y-B0

• Rad Hardened: No
• Product: Ceramic Filters
• Frequency: 455 KHz
• Impedance: 2 KOhms
• Termination Style: PCB
• Operating Temperature Range: - 20 C to + 80 C
• Lead Free Status / RoHS Status: Compliant

!Note
• This PDF catalog is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our
• This PDF catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
sales representatives or product engineers before ordering.
!Note
1. Do not use this product with bend. The component
2. The component will be damaged when an excessive
3. All kinds of re-flow soldering must not be applied
4. Do not clean or wash the component as it is not
5. Do not use strong acidity flux, more than 0.2wt%
CFULA Series
CFULB Series
CFWLA Series
CFWLB Series
The order quantity should be an integral multiple of the "Minimum Quantity" shown above.
may be damaged if excessive mechanical stress is
applied to it mounted on the printed circuit board.
stress is applied.
on the component.
hermetically sealed.
chlorine content, in flow soldering.
Minimum Quantity
Notice (Handling)
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
Part Number
Plastic Case Type CERAFILr Minimum Quantity/Notice
Bulk
200
250
150
150
6. In case of covering filter with over coat,
7. Accurate test circuit values are required to
8. For safety purposes, connect the output of filters
conditions such as material of resin, cure
temperature, and so on should be evaluated
carefully.
measure electrical characteristics.
It may be a cause of miscorrelation if there is
any deviation, especially stray capacitance, from
the test circuit in the specification.
to the IF amplifier through a D.C. blocking
capacitor. Avoid applying a direct current to the
output of ceramic filters.
Magazine
80
50
55
(pcs.)
47
P05E.pdf
08.1.22
16