S2S3A00F Sharp Microelectronics, S2S3A00F Datasheet - Page 9

• Manufacturer Part Number: S2S3A00F
• Description: Triac & SCR Output Optocouplers 10mA Ift 600V nonZC Phototriac 3Kpcs
• Manufacturer: Sharp Microelectronics

Specifications of S2S3A00F

• Configuration: 1
• Maximum Continuous Output Current: 50 mA
• Maximum Input Current: 50 mA
• Maximum Operating Temperature: + 100 C
• Maximum Reverse Diode Voltage: 6 V
• Maximum Turn-on Time: 100 us
• Minimum Operating Temperature: - 30 C
• Output Type: AC
• Package / Case: Mini-flat
• Typical Input Voltage: 1.2 V
• Zero-crossing Circuit: No
• Output Device: PhotoTriac
• Isolation Voltage: 3.75 V
• Peak Output Voltage (vdrm): 600 V
• Maximum Input Voltage: 1.4 V
• Maximum Output Voltage: 420 VAC
• Minimum Trigger Current: 10 mA (Max)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

■ Design Considerations
● Degradation
● Recommended Foot Print (reference)
● Design guide
In order for the Phototriac to turn off, the triggering current (I
Please refrain from using these devices in a direct drive configuration.
These Phototriac Coupler are intended to be used as triggering device for main Triacs.
Please ensure that the output rating of these devices will be sufficient for triggering the main output Triac of
your choice. Failure to do may result in malfunctions.
In phase control applications or where the Phototriac Coupler is being by a pulse signal, please ensure that
the pulse width is a minimum of 1ms.
For designs that will experience excessive noise or sudden changes in load voltage, please include an
appropriate snubber circuit as shown in the below circuit.
Please keep in mind that Sharp Phototriac Couplers incorporate superor dV/dt ratings which can often
eliminate the need for a snubber circuit.
In general, the emission of the IRED used in Phototriac Couplers will degrade over time.
In the case where long term operation and / or constant extreme temperature fluctuations will be applied to
the devices, please allow for a worst case scenario of 50% degradation over 5years.
Therefore in order to maintain proper operation, a design implementing these Phototriac Couplers should
provide at least twice the minimum required triggering current from initial operation.
1.5
9
6.3
F
), must be 0.1mA or less.
Sheet No.: D2-A06501EN
S2S3 Series
(Unit : mm)