CDB61880 Cirrus Logic Inc, CDB61880 Datasheet - Page 9

• Manufacturer Part Number: CDB61880
• Description: Audio Modules & Development Tools Eval Bd Octal E1 Line Interface Unit
• Manufacturer: Cirrus Logic Inc

Specifications of CDB61880

• Description/function: Audio DSPs
• Operating Supply Voltage: 5 V
• Product: Audio Modules
• For Use With/related Products: CS61880
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

2.13 Digital Signal Connections
There are eight fourteen pin bed stake headers (la-
beled J4 through J11) that provide access to the
digital signals used to interface with back-end de-
vices (framers, mappers, ASIC, etc.) and all eight
LOS signals, in both Hardware And Host mode.
Figure 10
pin bed stake headers used to access the back-end
digital signals, LOS signals and the different set-
tings for the TCLK/TNEG pins.
2.14 LOS Indicators
The two 4-LED packs D1 and D2 (labeled ALOS
0-7) represent the LOS signal status for LOS 0-7
pins. The ALOS 0-7 LEDs will illuminate when the
DS450DB1
RZ mode active when
TAOS active when
MCLK present
MCLK absent
Bi-polar Mode
Figure 10. Digital Signal Control/Access
shows the layout for one of the eight 14-
Uni-Polar Mode Active
Transmitters High-Z
corresponding receiver has detected a loss of signal
condition. Refer to the CS61880 Data Sheet for
LOS conditions.
2.15 JTAG Connection
A 5-pin bed stake header (J60) is provided to allow
easy access to the IEEE 1149.1 JTAG Boundary
Scan signals from the device.
2.16 Host Interface Connection
Connector J12 is used to connect the CS61880
evaluation board to the host computer, through a
standard 25 pin male to female parallel port cable.
No external µController board is required for host
interface connection. This connector is used for
both serial and parallel interface.
3. HOST SETUP DESCRIPTION
Place the switches shown in Table 3 to the stated
configuration before setting the Mode switch (S15)
to Serial or Parallel Host mode. Refer to
on page 6
- Switches #1 and #2 inside of switch block S9
are used in Parallel Host mode to select
Motorola, Intel, multiplex or Non-multiplex
modes. Switch S9 #1 and #2 are not used in
Serial Host mode.
S9 # 3 through # 7
S12 through S14
S1 through S8
Table 3. Switch Settings for Host Mode
Switch
for switch S15 settings.
S10
S11
NONE (middle)
OPEN (middle)
OPEN (middle)
OPEN (low)
NC (middle)
Position
CDB61880
Figure 4
9