SB72-301CR NetBurner Inc, SB72-301CR Datasheet - Page 32

• Manufacturer Part Number: SB72-301CR
• Description: Ethernet Modules & Development Tools 32Bit 62MHz Single Board Module RJ45
• Manufacturer: NetBurner Inc

Specifications of SB72-301CR

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

32
DQ6 status bits, just as in the standard program operation. See
information.
The system may also write the autoselect command sequence when the device is in the Erase Suspend
mode. The device allows reading autoselect codes even at addresses within erasing sectors, since the codes
are not stored in the memory array. When the device exits the autoselect mode, the device reverts to the
Erase Suspend mode, and is ready for another valid operation. See
on page 28
The system must write the Erase Resume command (address bits are don’t care) to exit the erase suspend
mode and continue the sector erase operation. Further writes of the Resume command are ignored. Another
Erase Suspend command can be written after the device has resumed erasing.
Notes
1. See
2. See
Table 10.1 on page 33
DQ3: Sector Erase Timer on page 38
for more information.
for erase command sequence.
for more information.
No
Figure 10.2 Erase Operation
S29AL008J
Command Sequence
Erasure Completed
Write Erase
from System
Data = FFh?
D a t a
Data Poll
START
Yes
S h e e t
Embedded
Erase
algorithm
in progress
Write Operation Status on page 34
Autoselect Command Sequence
S29AL008J_00_09 February 23, 2010
for more