II-EVB-600-3-110/220 Connect One, II-EVB-600-3-110/220 Datasheet - Page 30

• Manufacturer Part Number: II-EVB-600-3-110/220
• Description: Ethernet Modules & Development Tools iChipSec CO2064 Eval Board
• Manufacturer: Connect One
• Type: Evaluation Boardsr

Specifications of II-EVB-600-3-110/220

• Interface Type: RS-232, Ethernet, USB
• Operating Voltage: 110 V, 220 V
• Product: Modules
• For Use With/related Products: CO2064SEC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

II-EVB-600 User Manual
This dialog box is also displayed if you select Serial Ports from the menu bar.
3. From the Serial Port drop-down list, select the port to which the II-EVB-600 is attached.
4. In the Baud Rate area:
If Scan is selected, iChipConfig Utility runs through the different baud rates until the correct
baud rate to be used is found. The following message is displayed:
Note: If iChipConfig Utility still fails to find the II-EVB-600, make sure that there are no
applications open, such as Palm HotSync, occupying the port; switch to a different COM port and
try Scan again. After iChipConfig has found the baud rate, you can easily change it by opening
the Serial Settings dialog box and selecting the desired baud rate.
2.10
To be part of the LAN, the II-EVB-600 needs basic LAN settings, such as IP Address, Subnet and
Gateway IP address. There are two ways to configure this set of parameters for II-EVB-600:
Getting Started




Select the exact Baud Rate used by the II-EVB-600.
-or-
Select Scan if you don’t know the baud rate.
Dynamic IP Allocation (Via DHCP)
Fixed IP Configuration (Via User Assignment)
Configuring for Connection
Getting Started
25