EN5366QI-E Enpirion, EN5366QI-E Datasheet - Page 2

• Manufacturer Part Number: EN5366QI-E
• Description: Power Management Modules & Development Tools 6AMP MOD INT IND EVAL BOARD
• Manufacturer: Enpirion
• Type: DC/DC Switching Converters, Regulators & Controllersr

Specifications of EN5366QI-E

• Input Voltage: 2.4 V to 5.5 V
• Output Voltage: 0.8 V to 3.3 V
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Product: Power Management Modules
• For Use With/related Products: EN5366QI

Quick Start Guide
Figure 1 shows a top view of the evaluation board.
STEP 1: Set the “ENABLE” jumper to the Disable
Position.
STEP 2: Connect Power Supply to the input power connectors, VIN (+) and
GND (-) as indicated in Figure 1.
STEP 3: Connect the load to the output connectors VOUT (+) and GND (-), as
indicated in Figure 1.
STEP 4: Apply V
position. The EN5366QI is now powered up!
WARNING: complete steps 1 through 4 before
applying power to the EN5366QI evaluation
board.
CAUTION: be mindful of the polarity. Even though the evaluation board
comes with reverse polarity protection diodes, it is rarely a good idea to
reverse the input polarity.
NOTE: There is no de-bouncing circuitry associate with the enable pin.
NOTE: The trim pot is set at the factory to a predetermined output voltage.
To adjust to another output voltage setting, turn the screw on the trim pot
while monitoring the output voltage using an accurate volt-meter.
IN
to the board and move the ENABLE jumper to the enabled
Page 2 of 5
EN5366QI Evaluation Board Application Note
November 2006 V_1
Jumper set
Jumper set
to “disable”
to “disable”