ADP32 EETools, ADP32 Datasheet - Page 28

• Manufacturer Part Number: ADP32
• Description: Programming Socket Adapters & Emulators EEROM-8U ADAPTER 32-PIN PLCC PACKAGE
• Manufacturer: EETools
• Type: EeRom-8U Adapter/EPROM >512Kbitr

Specifications of ADP32

• Description/function: Programmer Accessories EEROM-8U Adapter 32-Pin PLCC Package
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Wrong PLCC or other adapters used.
Any adapter used between the target cable and the target socket itself has the
potential of introducing errors.
model and manufacturer. In general, small EPROMs (<1Mbit) generally have one pin
out and larger EPROMs have a different pin out. Most FLASH chips are pinned out like
large EPROMs. However, SOME small FLASH are wired like SMALL EPROMs. In general,
large devices (>=1Mbit) use a 32 pin DIP to 32 pin PLCC adapter. Smaller devices
usually need a 28 pin DIP to 32 pin PLCC adapter but MIGHT need the 32 pin version.
Give us a call if you are not sure.
Common problems and solutions
www.eetools.com
1). Software doesn’t recognize EeRom-8U device
2). After downloading and Target Run, Target doesn’t seem to be performing
correctly.
3). Software is down and stops performing.
4). Reset doesn’t start.
- Check that red Power LED of EeRom-8U is on.
- Check that USB Cable is connected correctly.
- Click “Setting” -> “Hardware Profile” -> “Device Manager”-> “Universal Bus
Controller” and check that the corresponding driver is loaded correctly.
- If you have any further questions, please contact with our technical
assistances.
- Check that green light of Status LED is on when downloading.
- Check that the selected Target power and EeRom-8U power are correct.
- Check that the Cable and the socket are connected properly to Target.
- If you have any further questions, please contact with our technical
- Unplug USB Cable and shut down Software.
- After a while, connect the Cable again and start Software.
- If matter seems not to be better, please contact with our technical assistances.
- Check that Reset Cable is connected properly to Reset pin that is placed in the
side of EeRom-8U.
- Check that Reset Cable is connected to the right Reset terminal of Target.
- Check that the selected Reset Type is correct from Option of Software and the
assistances.
In particular, PLCC footprints vary by EPROM size,
- 28 -