553444-2 TE Connectivity, 553444-2 Datasheet - Page 4

• Manufacturer Part Number: 553444-2
• Manufacturer: TE Connectivity
• Type: IEEE 488r

Specifications of 553444-2

• Gender: PL
• Number Of Contacts: 24POS
• Contact Material: Copper Alloy
• Contact Plating: Gold Over Nickel
• Number Of Ports: 1Port
• Body Orientation: Straight
• Pitch (mm): 2.16mm
• Number Of Terminals: 24
• Housing Material: Polyester
• Mounting Style: Through Hole
• Termination Method: Solder
• Product Type: Connector
• Product Line: CHAMP
• Pcb Mount Style: Vertical
• Orientation: Standard
• Profile: Standard
• Mating Connector Lock: Without
• Pcb Mount Retention: Without
• Grounded: No
• Panel Thickness (mm [in]): 2.36 [0.093]
• Color: Natural
• Panel Mount Retention: With
• Panel Attachment Style: Rear Mount
• Shielded: No
• Centerline (mm [in]): 2.16 [0.085]
• Number Of Positions: 24
• Contact Plating, Mating Area, Material: Gold
• Contact Base Material: Copper Alloy
• Connector Style: Plug
• Ul Flammability Rating: UL 94V-0
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant
• Pcb Thickness, Recommended (mm [in]): 1.57 – 3.18 [0.062 – 0.1251]
• Lead Free Status / RoHS Status: Compliant

4.
4.1.
4.2.
4.3.
4.4.
Rev D
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of original testing
sequence as determined by development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that product meets requirements of Figure 1. Failures attributed to
equipment, test setup or operator deficiencies shall not disqualify product. When product failure occurs,
corrective action shall be taken and samples resubmitted for qualification. Testing to confirm corrective
action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan will specify sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with applicable product drawing and
this specification.
Sample Selection
Connector housings and contacts shall be prepared in accordance with applicable Instruction
Sheets and shall be selected at random from current production. Test groups 1, 3, 4, 5, 6, 7 and 8
shall consist of 2, 50 position connectors. Test group 2 shall consist of 2, 50 position connectors
with self-retained (barb) terminals. When samples are mounted, printed circuit boards shall
conform to IPC-A-600.
Test Sequence
Qualification inspection shall be verified by testing samples as specified in Figure 2.
Mounting Mated Samples To Test Board For Millivolt Dr
Figure 3
108-6019
4 of 5