NCP512SQ27T2G ON Semiconductor, NCP512SQ27T2G Datasheet - Page 6

• Manufacturer Part Number: NCP512SQ27T2G
• Description: IC REG VOLTAGE 180MA 2.7V SC88A
• Manufacturer: ON Semiconductor

Specifications of NCP512SQ27T2G

• Regulator Topology: Positive Fixed
• Voltage - Output: 2.7V
• Voltage - Input: Up to 6V
• Voltage - Dropout (typical): 0.2V @ 80mA
• Number Of Regulators: 1
• Current - Output: 200mA
• Current - Limit (min): -
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 6-TSSOP (5 lead), SC-88A, SOT-353
• Number Of Outputs: 1
• Input Voltage Max: 6 V
• Output Voltage: 2.7 V
• Output Type: Fixed
• Dropout Voltage (max): 300 mV
• Output Current: 200 mA
• Load Regulation: 0.3 mV
• Voltage Regulation Accuracy: 2 %
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Load Regulation
current at a constant temperature.
Dropout Voltage
no longer maintains regulation against further reductions in
input voltage. Measured when the output drops 3.0% below
its nominal. The junction temperature, load current, and
minimum input supply requirements affect the dropout level.
Maximum Power Dissipation
will operate within its specifications.
Quiescent Current
the ground when the LDO operates without a load on its
output: internal IC operation, bias, etc. When the LDO
becomes loaded, this term is called the Ground current. It is
actually the difference between the input current (measured
through the LDO input pin) and the output current.
The change in output voltage for a change in output
The input/output differential at which the regulator output
The maximum total dissipation for which the regulator
The quiescent current is the current which flows through
http://onsemi.com
DEFINITIONS
6
Line Regulation
The measurement is made under conditions of low
dissipation or by using pulse technique such that the average
chip temperature is not significantly affected.
Line Transient Response
is excited with a given slope.
Thermal Protection
the integrated circuit in the event that the maximum junction
temperature is exceeded. When activated at typically 160°C,
the regulator turns off. This feature is provided to prevent
failures from accidental overheating.
Maximum Package Power Dissipation
dissipation level at which the junction temperature reaches
its maximum operating value, i.e. 125°C. Depending on the
ambient power dissipation and thus the maximum available
output current.
The change in output voltage for a change in input voltage.
Typical over and undershoot response when input voltage
Internal thermal shutdown circuitry is provided to protect
The maximum power package dissipation is the power