AD5311BRTZ-REEL7 Analog Devices Inc, AD5311BRTZ-REEL7 Datasheet - Page 19

• Manufacturer Part Number: AD5311BRTZ-REEL7
• Description: IC,D/A CONVERTER,SINGLE,10-BIT,CMOS,TSOP,6PIN
• Manufacturer: Analog Devices Inc

Specifications of AD5311BRTZ-REEL7

• Settling Time: 7µs
• Number Of Bits: 10
• Data Interface: I²C, Serial
• Number Of Converters: 1
• Voltage Supply Source: Single Supply
• Power Dissipation (max): 1.4mW
• Operating Temperature: -40°C ~ 105°C
• Mounting Type: Surface Mount
• Package / Case: SOT-23-6
• Number Of Channels: 1
• Resolution: 10b
• Conversion Rate: 143KSPS
• Interface Type: Serial (2-Wire/I2C)
• Single Supply Voltage (typ): 3.3/5V
• Dual Supply Voltage (typ): Not RequiredV
• Architecture: Resistor-String
• Power Supply Requirement: Single
• Output Type: Voltage
• Integral Nonlinearity Error: ±4LSB
• Single Supply Voltage (min): 2.5V
• Single Supply Voltage (max): 5.5V
• Dual Supply Voltage (min): Not RequiredV
• Dual Supply Voltage (max): Not RequiredV
• Operating Temp Range: -40C to 105C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 6
• Package Type: SOT-23
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: AD5311BRTZ-REEL7

POWER SUPPLY DECOUPLING
In any circuit where accuracy is important, careful considera-
tion of the power supply and ground return layout helps to
ensure the rated performance. The AD5301/AD5311/AD5321
should be decoupled to GND with 10 μF in parallel with a
0.1 μF capacitor, located as close to the package as possible.
The 10 μF capacitor should be the tantalum bead type, while
MASTER
A1
A0
SDA
AD5301
V
OUT
SCL
R
P
Figure 38. Multiple AD5301 Devices on One Bus
V
DD
R
P
5V
A1
A0
SDA
AD5301
Rev. B | Page 19 of 24
V
OUT
SCL
V
DD
a ceramic 0.1 μF capacitor provides a sufficient low impedance
path to ground at high frequencies. The power supply lines of
the AD5301/AD5311/AD5321 should use as large a trace as
possible to provide low impedance paths. A ground line routed
between the SDA and SCL lines helps reduce crosstalk between
them. This is not required on a multilayer board as there is a
ground plane layer, but separating the lines helps.
A1
A0
SDA
AD5301
V
OUT
SCL
V
DD
AD5301/AD5311/AD5321
SDA
A1
A0
AD5301
V
OUT
SCL
SDA
SCL