CS4385-CQZR Cirrus Logic Inc, CS4385-CQZR Datasheet - Page 43

• Manufacturer Part Number: CS4385-CQZR
• Description: IC,D/A CONVERTER,OCTAL,24-BIT,QFP,48PIN
• Manufacturer: Cirrus Logic Inc

Specifications of CS4385-CQZR

• Number Of Bits: 24
• Data Interface: Serial
• Number Of Converters: 8
• Voltage Supply Source: Analog and Digital
• Power Dissipation (max): 520mW
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 48-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: 598-1154 - BOARD EVAL FOR CS4385 DAC
• Settling Time: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

DS671F2
6.8.2 Soft Volume Ramp-Up after Error (RMP_UP)
6.8.3 Soft Ramp-Down before Filter Mode Change (RMP_DN)
6.8.4 PCM Auto-Mute (PAMUTE)
Soft Ramp on Zero Crossing
Soft Ramp and Zero Cross Enable dictates that signal-level changes, either by attenuation changes or
muting, will occur in 1/8 dB steps and be implemented on a signal zero crossing. The 1/8 dB level change
will occur after a timeout period between 512 and 1024 sample periods (10.7 ms to 21.3 ms at 48 kHz
sample rate) if the signal does not encounter a zero crossing. The zero cross function is independently
monitored and implemented for each channel.
Function:
An un-mute will be performed after executing an LRCK/MCLK ratio change or error, and after changing
the Functional Mode.
When set to 1 (default), this unmute is effected, similar to attenuation changes, by the Soft and Zero Cross
bits in the Volume and Mixing Control register.
When set to 0, an immediate unmute is performed in these instances.
Note:
Function:
If either the FILT_SEL or DEM bits are changed the DAC will stop conversion for a period of time to
change its filter values. This bit selects how the data is effected prior to and after the change of the filter
values.
When set to 1 (default), a mute will be performed prior to executing a filter mode change and an un-mute
will be performed after executing the filter mode change. This mute and un-mute are effected, similar to
attenuation changes, by the Soft and Zero Cross bits in the Volume and Mixing Control register.
When set to 0, an immediate mute is performed prior to executing a filter mode change.
Note:
Function:
When set to 1 (default), the Digital-to-Analog converter output will mute following the reception of 8192
consecutive audio samples of static 0 or -1. A single sample of non-static data will release the mute. De-
tection and muting is done independently for each channel. The quiescent voltage on the output will be
retained and the Mute Control pin will go active during the mute period.
When set to 0, this function is disabled.
For best results, it is recommended that this feature be used in conjunction with the RMP_DN bit.
For best results, it is recommended that this feature be used in conjunction with the RMP_UP bit.
CS4385
43