CS5343-CZZR Cirrus Logic Inc, CS5343-CZZR Datasheet - Page 18

• Manufacturer Part Number: CS5343-CZZR
• Description: IC,A/D CONVERTER,DUAL,24-BIT,TSSOP,10PIN
• Manufacturer: Cirrus Logic Inc

Specifications of CS5343-CZZR

• Number Of Bits: 24
• Sampling Rate (per Second): 108k
• Data Interface: Serial
• Number Of Converters: 2
• Power Dissipation (max): 85mW
• Voltage Supply Source: Single Supply
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 10-TSSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: 598-1156 - BOARD EVAL FOR CS5343 STEREO ADC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

18
6. PARAMETER DEFINITIONS
Dynamic Range
Total Harmonic Distortion + Noise
Frequency Response
Interchannel Isolation
Interchannel Gain Mismatch
Gain Error
Gain Drift
The ratio of the rms value of the signal to the rms sum of all other spectral components over the specified
bandwidth. Dynamic Range is a signal-to-noise ratio measurement over the specified bandwidth made with
a -60 dBFS signal. 60 dB is added to resulting measurement to refer the measurement to full-scale. This
technique ensures that the distortion components are below the noise level and do not affect the measure-
ment. This measurement technique has been accepted by the Audio Engineering Society, AES17-1991,
and the Electronic Industries Association of Japan, EIAJ CP-307. Expressed in decibels.
The ratio of the rms value of the signal to the rms sum of all other spectral components over the specified
bandwidth (typically 10 Hz to 20 kHz), including distortion components. Expressed in decibels. Measured
at -1 and -20 dBFS as suggested in AES17-1991 Annex A.
A measure of the amplitude response variation from 10 Hz to 20 kHz relative to the amplitude response at
1 kHz. Units in decibels.
A measure of crosstalk between the left and right channels. Measured for each channel at the converter's
output with no signal to the input under test and a full-scale signal applied to the other channel. Units in deci-
bels.
The gain difference between left and right channels. Units in decibels.
The deviation from the nominal full-scale analog input for a full-scale digital output.
The change in gain value with temperature. Units in ppm/°C.
4/2/08
Draft
CS5343/4
DS687F3