CS8420-DSZR Cirrus Logic Inc, CS8420-DSZR Datasheet - Page 41

• Manufacturer Part Number: CS8420-DSZR
• Description: IC,Digital Audio Sample Rate Converter,SOP,28PIN
• Manufacturer: Cirrus Logic Inc

DS245F4
10.9
VFIFO
REUNLOCK
DETU
EFTU
QCH
UOVW
10.10 Interrupt 1 Register Mask (09h)
10.11 Interrupt Register 1 Mode Registers MSB & LSB (0Ah,0Bh)
TSLIPM
TSLIP1
TSLIP0
7
7
7
0
Interrupt Register 2 Status (08h) (Read Only)
The bits of this register serve as a mask for the Interrupt 1 Register. If a mask bit is set to 1, the error is
considered unmasked, meaning that its occurrence will affect the INT pin and the status register. If a mask
bit is set to 0, the error is considered masked, meaning that its occurrence will not affect the INT pin or the
status register. The bit positions align with the corresponding bits in Interrupt Register 1. This register de-
faults to 00.
The two Interrupt Mode registers form a 2-bit code for each Interrupt Register 1 function. This code deter-
mines whether the INT pin is set active on the arrival of the interrupt condition, on the removal of the interrupt
condition, or on the continuing occurrence of the interrupt condition. These registers default to 00.
00 - Rising edge active
01 - Falling edge active
10 - Level active
11 - Reserved
OSLIPM
OSLIP1
OSLIP0
For all bits in this register, a “1” means the associated interrupt condition has occurred at least
once since the register was last read. A”0” means the associated interrupt condition has NOT
occurred since the last reading of the register. Reading the register resets all bits to 0, unless
the interrupt mode is set to level and the interrupt source is still true. Status bits that are masked
off in the associated mask register will always be “0” in this register. This register defaults to 00.
Varispeed FIFO overflow indicator. Occurs if the data buffer in the SRC overflows. This will oc-
cur if the input sample rate slows too fast.
Sample rate converter unlock indicator. This interrupt occurs if the SRC is still tracking a chang-
ing input or output sample rate.
in the U bit buffer management process (block mode only).
E to F U-buffer transfer interrupt. The source of this bit is true during the E to F buffer transfer
in the U bit buffer management process (block mode only).
A new block of Q-subcode data is available for reading. The data must be completely read with-
in 588 AES3 frames after the interrupt occurs to avoid corruption of the data by the next block.
U-bit FIFO Overwrite. This interrupt occurs on an overwrite in the U-bit FIFO.
D to E U-buffer transfer interrupt. The source of this bit is true during the D to E buffer transfer
6
6
6
0
SREM
VFIFO
SRE1
SRE0
5
5
5
REUNLOCK
OVRGLM
OVRGL1
OVRGL0
4
4
4
OVRGRM
OVRGR1
OVRGR0
DETU
3
3
3
DETCM
DETC1
DETC0
EFTU
2
2
2
EFTCM
EFTC1
EFTC0
QCH
1
1
1
CS8420
RERRM
RERR1
RERR0
UOVW
0
0
0
41