EPM7064AELI44-7 Altera, EPM7064AELI44-7 Datasheet - Page 26

• Manufacturer Part Number: EPM7064AELI44-7
• Description: MAX 7000/S/AE/B
• Manufacturer: Altera

MAX 7000A Programmable Logic Device Data Sheet
Notes to tables:
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10) For EPM7128A and EPM7256A devices, this pull-up exists while a device is programmed in-system.
(11) For MAX 7000AE devices, this pull-up exists while devices are programmed in-system and in unprogrammed
(12) Capacitance is measured at 25 C and is sample-tested only. The
(13) The POR time for MAX 7000AE devices (except MAX 7128A and MAX 7256A devices) does not exceed 100 s. The
26
See the Operating Requirements for Altera Devices Data Sheet.
Minimum DC input voltage is –0.5 V. During transitions, the inputs may undershoot to –2.0 V for input currents
less than 100 mA and periods shorter than 20 ns.
For EPM7128A and EPM7256A devices only, V
In MAX 7000AE devices, all pins, including dedicated inputs, I/O pins, and JTAG pins, may be driven before
V
These devices support in-system programming for –40
–40
These values are specified under the recommended operating conditions shown in
The parameter is measured with 50% of the outputs each sourcing the specified current. The I
to high-level TTL or CMOS output current.
The parameter is measured with 50% of the outputs each sinking the specified current. The I
low-level TTL or CMOS output current.
This value is specified for normal device operation. For MAX 7000AE devices, the maximum leakage current during
power-up is ±300 A. For EPM7128A and EPM7256A devices, leakage current during power-up is not specified.
devices during power-up.
has a maximum capacitance of 20 pF.
sufficient V
reaches the sufficient POR voltage level.
CCINT
°
and 0
and V
°
CCINT
C, contact Altera Applications.
CCIO
voltage level for POR is 3.0 V. The device is fully initialized within the POR time after V
are powered.
CC
must rise monotonically.
°
to 100
°
C. For in-system programming support between
OE1
pin (high-voltage pin during programming)
Table 11 on page
Altera Corporation
OL
OH
parameter refers to
parameter refers
24.
CCINT