ZMOTIONL100ZCOG Zilog, ZMOTIONL100ZCOG Datasheet - Page 14

• Manufacturer Part Number: ZMOTIONL100ZCOG
• Description: EVALUATION KIT Z8FS040 ZMOTION
• Manufacturer: Zilog
• Series: ZMOTION™r

Specifications of ZMOTIONL100ZCOG

• Sensor Type: Motion, PIR (Pyroelectric Infrared)
• Sensing Range: 5m x 5m, 60 Degree Detection Pattern
• Interface: Serial
• Sensitivity: Adjustable
• Voltage - Supply: 5V
• Embedded: Yes
• Utilized Ic / Part: Z8FS040B
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 269-2511

PS028511-0112
Signal Mnemonic
General-Purpose I/O Ports A–D
PA[7:0]
PB[5:0]
PC[7:0]
PD[0]
UART Controllers
TXD0
RXD0
CTS0
DE
Timers
T0
T0
T0
Comparator
C
C
IN
OUT
OUT
OUT
IN
P/C
/T1IN
Signal Descriptions
/T1
/T1
IN
N
OUT
OUT
At reset, all port pins are set to the GPIO input state on the 8-pin SOIC package except for
RESET/DE0/T1
which is configured to DBG. On the 20- and 28-pin SSOP packages, RESET/PD0 is con-
figured to RESET.
Table 3 describes the Z8FS040 Series signals.
I/O
I/O
I/O
I/O
O
O
I
I
O
O
O
I
I
O
Table 3. Z8FS040 MCU Signal Descriptions
OUT
Description
Port A. These pins are used for general-purpose I/O.
Port B. These pins are used for general-purpose I/O.
Port C. These pins are used for general-purpose I/O.
IrDA.
Receive Data. This signal is the receive input for the UART and IrDA.
drivers. It is approximately the inverse of the Transmit Empty (TXE) bit in
the UART Status 0 Register. The DE signal can be used to ensure that
the external RS-485 driver is enabled when data is transmitted by the
UART.
Timer Output 0–1. These signals are outputs from the timers.
Timer Complement Output 0–1. These signals are output from the timers
in PWM DUAL OUTPUT Mode.
Timer Input 0–1. These signals are used as the capture, gating and
counter inputs.
Comparator Inputs. These signals are the positive and negative inputs to
the comparator.
Comparator Output.
Port D. This pin is used for general-purpose output only.
Transmit Data. This signal is the transmit output from the UART and
Clear To Send. This signal is the flow control input for the UART.
Driver Enable. This signal allows automatic control of external RS-485
, which is configured to RESET, and PA0/T0
ZMOTION™ Detection and Control Family
Product Specification
IN
/T0
OUT
Signal Descriptions
/X
IN
/DBG,
7