MTCBA-C1-EN2-N3-NAM Multi-Tech Systems, MTCBA-C1-EN2-N3-NAM Datasheet - Page 14

• Manufacturer Part Number: MTCBA-C1-EN2-N3-NAM
• Description: ROUTER WIRELESS DUAL CDMA
• Manufacturer: Multi-Tech Systems
• Series: MultiModem® rCellr

Specifications of MTCBA-C1-EN2-N3-NAM

• Function: Transceiver, CDMA, Router
• Modulation Or Protocol: CDMA2000
• Frequency: 800MHz, 1.9GHz
• Applications: Verizon™ Networks (USA)
• Interface: RJ-45, RS-232
• Features: US Power Cord
• Voltage - Supply: 9 V ~ 32 V
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 881-1067

Chapter 2 – Installation
14
5.
Screw-on the power lead from the power supply module into the power connection on the router. Now, plug the
power supply into your power source.
For Optional Direct DC Power
●
●
●
Warning:
Note:
Notes
Powering Down and Hardware Resetting a MTCBA-C1-EN2 Router
It is recommended to follow the following shutdown sequence, when possible, prior to a hardware
reset or turning off of power to the router.
The shutdown sequence informs the network that the mobile station is going offline, and saves
critical data to the module‘s non-volatile memory (flash).
AT+CFUN=0 (issue this command)
+WIND:10
Router is now ready to be powered off or reset.
If you do not see the +WIND:10 response, you may need to activate the unsolicited message by
using the command AT+WUSLMSK=00020000,0
Screw-on the DC power cable to the power connector on the router.
Then attach the two wires at the other end of the DC power cable to a DC fuse/terminal block in which you are
mounting the router.
Connect the red wire to the "+" (positive) terminal and the black wire to the "–" (negative) terminal. Be sure
the GND connection is correct.
●
●
● The
add additional filtering to the DC input.
the power supply to its source (for example, in a mobile situation, to the DC fuse/terminal block).
The
When the
the username and password back to admin and admin as well as setting the IP address to the default of
192.168.2.1.
For an application involving a battery: you can use permanent “+” or key-switched “+” source. Connect
The
Over-voltage protection is provided on the device. To ensure complete protection, you may want to
Status
Reset Button.
POWER LED.
(Wait for this response from the modem)
Status
LED is a solid ON when the router is booting up, saving a configuration, or updating firmware.
LED begins to blink, the router is ready.
Hold the
The
POWER
Reset
LED lights after power-up.
button in until the Status Light goes out. Then release it. It also will set
Multi-Tech Systems, Inc. MultiModem rCell User Guide