FLUKE-27YEL Fluke Electronics, FLUKE-27YEL Datasheet - Page 23
![no-image](/images/no-image-200.jpg)
FLUKE-27YEL
Manufacturer Part Number
FLUKE-27YEL
Description
MULTIMETER YELLOW COLOR
Manufacturer
Fluke Electronics
Series
TouchHold®, 20r
Type
Digital (DMM)r
Datasheet
1.FLUKE-27YEL.pdf
(30 pages)
Specifications of FLUKE-27YEL
Includes
Battery, Clips, Test Leads
Style
Handheld
Display Digits
3.75
Display Type
LCD, Bar Graph
Display Count
3200
Function
Voltage, Current, Resistance
Functions, Extra
Continuity, Diode Test
Features
Hold, MIN/MAX
Ranging
Auto/Manual
Response
Average
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
739169
Fuse Test
1.
2.
3.
4.
To avoid possible electric shock or personal
injury:
To prevent arc blast and resulting injury,
install only the EXACT replacement fuse
listed in Table 4.
Turn the function selector switch to the
Connect a test lead from the T input terminal
to the A input terminal.
The display should indicate between 0.1 ohm and
0.3 ohm. This tests F2 (11A, 1000V fast).
Move one end of the test lead from the A input
terminal to the mA/ A input terminal.
Remove the test leads and any input
signals before replacing battery or fuses.
Before closing battery door, make sure
fuse cover is in place.
Make sure the battery door is closed and
latched before you operate the meter.
WWarnings
position.
5.
6.
Fuse Replacement
Referring to Figure 1, use the following procedure to
check or replace the Fluke 27 fuses:
1.
2.
3.
4.
5.
The display should indicate between 5.3 ohms and
6.0 ohms. This tests F1 (44/100A, 1000V fast.
If either of the above display indications is OL
(overload), replace the appropriate fuse.
To avoid personal injury, do not use
makeshift fuses or short-circuit the fuse
holders.
Perform steps 1 through 4 of the battery replacement
procedure.
Pull the fuse cover down, then out of the meter.
Remove the defective fuse (or check continuity
through the suspected fuse), and if necessary install
a new fuse of the same size and rating.
Snap the fuse cover back into place.
Reinstall the battery spacer/cover as instructed in
step 6 of the battery replacement procedure.
WWarning
Operator Maintenance
19