XR2A-2001-N Omron, XR2A-2001-N Datasheet - Page 11

• Manufacturer Part Number: XR2A-2001-N
• Description: CONNECTOR
• Manufacturer: Omron
• Series: XR2r
• Type: DIP, 0.3" (7.62mm) Row Spacingr

Specifications of XR2A-2001-N

• Number Of Positions Or Pins (grid): 20 (2 x 10)
• Pitch: 0.100" (2.54mm)
• Mounting Type: Through Hole
• Features: Open Frame
• Contact Finish: Gold
• Contact Finish Thickness: 30µin (0.76µm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: XR2A2001N; XR2A2001NNC

■ Tools and Accessories
■ Precautions
Correct Use
Soldering
• When soldering, make sure that the outer
• Make sure that no flux enters the IC
XY2C-0101
XY2C-0103
IC Removal Tool
XR2Z-11
IC Holder (made from PBT)
sleeve of the IC Socket does not stick out
of the circuit board through-holes.
Socket from the top.
Note: Order the following models in multiples of the minimum order.
XR2Z-11
XR2Z-13
Model
No. of IC Socket contacts IC socket width
14, 16, 18, 20, 24
24, 28, 32, 40, 42, 48
XY2C-0101 14, 16, 18, 20
XY2C-0103 24, 28, 32, 40
Model
Removing ICs
• Use the XY2C-0101 or XY2C-0103 IC
• Do not use a screwdriver to remove the
• Do not use a testing rod or check pin to
• Four-point contact construction is used for
Automated Soldering
Conditions (Jet Flow)
1. Soldering temperature: 250±5°C
2. Continuous soldering time: Within 5 s
7.62 m
15.24 mm
Removal Tool to remove ICs.
IC. It may damage the circuit board.
check contacts or circuits. This may dam-
age the inner clips or plating and may
lead to improper contact.
plated products to make them more toler-
ant of momentary power interruptions.
We recommend using gold-plated con-
tacts in areas subject to vibration and
shock.
No. of IC Socket contacts
XR2Z-13
100
500
Order in multiples of
7.62 m
15.24 mm
IC socket width
Note: This Holder protects the IC
Applicable IC Lead
Dimensions
1. Use leads that are within the range
2. Use an IC with tapered leads for easy
shown here. For details, refer to the first
page of this datasheet. Use an IC with
leads longer than 3 mm. If the leads are
too long, the IC will not sit flush on the
board.
insertion, a minimum amount of bend-
ing, and minimum damage to the leads.
IC Sockets
from falling out due to shock.
The IC will not fall out even
with a 980 m/s
cable IC height: 2.7 to 5.6 mm.
NG
XR2
2
shock. Appli-
OK
121
OK