XW2B-2 Omron, XW2B-2 Datasheet - Page 10

• Manufacturer Part Number: XW2B-2
• Description: Connector (Unit, Expansion)
• Manufacturer: Omron

Specifications of XW2B-2

• Product: Tools & Accessories
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Safety Precautions
● Wiring
● Wiring Terminal Blocks
Note: Round rod and blade crimp terminals are made by Nichifu.
• Always turn OFF the power supply before wiring.
• Do not connect or disconnect Connectors with the power
• Direct Wire Connections with a Terminal Block with M3
• Direct Wire Connections with a Terminal Block with M3.5
Otherwise, cables or other conductors can short the
terminals and cause the Unit to fail.
turned ON. Otherwise, it may cause malfunctions.
Screws
1. Use a wire size between 0.3 and 1.25 mm
2. Prepare the end of each wire as shown in the following
3. The wire insertion holes are 1.8 × 2.5 (H × W) mm on the
Screws
Round
Round rod
(With a Terminal Block with M3 Screws)
Applicable crimp terminals
Dia.
Applicable crimp terminals
AWG16).
diagram.
terminal block with M3 screws.
3.7 mm dia.
Forked
Round
Blade
Rod
6.8 mm max.
Precautions for Correct Use
6 mm
BT1.25-10-1
BT1.25-9-1
1.25Y-3.5
TC-1.25S
Dia. = 1.5
1.25-3.5
Dia. = 1
W = 2.2
Forked
Blade
2Y-3.5
TC-05
2-3.5
W
t = 0.75
3.7 mm
AWG22 to AWG16
AWG16 to AWG14
AWG22 to AWG16
AWG16 to AWG14
AWG22 to AWG18
AWG22 to AWG16
AWG22 to AWG16
(0.30 to 1.25 mm
(0.30 to 1.25 mm
(0.30 to 0.75 mm
(0.30 to 1.25 mm
(0.30 to 1.25 mm
Applicable wires
6.8 mm max.
Applicable wires
(1.25 to 2.0 mm
(1.25 to 2.0 mm
2
(AWG22 to
2
2)
2
2
2
2
2
)
)
)
)
)
)
● Terminal Screw Tightening Torque
● Mounting Units to and Removing Units from DIN Track
• Select a tightening torque from the following table when
• For terminal blocks with M3 screws, use a flat-heat
• XW2B Connector-Terminal Block Conversion Units can be
• Secure both ends of the XW2B with End Plates.
• When removing the Unit from a DIN Track, insert a flat-head
connecting wires or crimp terminals to the terminal block.
screwdriver like the one shown in the following diagram.
mounted side-to-side on DIN Track. The flanges for
mounting screws are located on each side at the bottom of
the XW2B.
screwdriver into the slider and pull the lock out.
With M3.5 screws
2.9- to 3.5-mm blade
Terminal Block
With M3 screws
Screw slot width: 0.7
Tightening torque
0.40
0.59
N⋅m
XW2B
10