ZB4BD204 SQUARE D, ZB4BD204 Datasheet - Page 4
![no-image](/images/manufacturer_photos/0/6/626/square_d_sml.jpg)
ZB4BD204
Manufacturer Part Number
ZB4BD204
Description
22MM NON-ILLUM SELECTOR SWITCH, RED KNOB
Manufacturer
SQUARE D
Datasheet
1.ZB4BD204.pdf
(5 pages)
Printed Circuit Board Cut-outs (Viewed from Electrical Block Side)
Dimensions in mm
A:
B:
Dimensions in in.
A:
B:
General Tolerances of the Panel and Printed Circuit Board
The cumulative tolerance must not exceed 0.3 mm / 0.012 in: T1 + T2 = 0.3 mm max.
Installation Precautions
The fixing centers marked a and b are diagonally opposed and must align with those marked 4 and 5.
4
30 mm min.
40 mm min.
1.18 in. min.
1.57 in. min.
● Minimum thickness of circuit board: 1.6 mm / 0.06 in.
● Cut-out diameter: 22.4 mm ± 0.1 / 0.88 in. ± 0.004
● Orientation of body/fixing collar ZB4 BZ009: ± 2
● Tightening torque of screws ZBZ 006: 0.6 N.m (5.3 lbf.in) max.
● Allow for one ZB4 BZ079 fixing collar/pillar and its fixing screws:
○ every 90 mm / 3.54 in. horizontally (X), and 120 mm / 4.72 in. vertically (Y).
○ with each selector switch head (ZB4 BD•, ZB4 BJ•, ZB4 BG•).
°
30’ (excluding cut-outs marked a and b).