A165E-S-01 Omron, A165E-S-01 Datasheet - Page 7
![E-stop,non-lighted,1NC,30diamt](/photos/14/98/149893/a165e-s-01_sml.jpg)
A165E-S-01
Manufacturer Part Number
A165E-S-01
Description
E-stop,non-lighted,1NC,30diamt
Manufacturer
Omron
Series
A16r
Type
Emergency Stopr
Specifications of A165E-S-01
Circuit
SPST-NC
Switch Function
On-Off
Contact Rating @ Voltage
5A @ 125VAC
Actuator Type
Round Button
Mounting Type
Panel Mount
Termination Style
Solder, Quick Connect - .110" (2.8mm)
Control Type
Emergency Stop
Contact Form
SPST - NC
Contact Rating
5 Amps at 125 VoltsAC
Illuminated
N
Contact Configuration
SPST-NC
Switch Operation
Pushlock Turn Reset
Contact Voltage Ac Nom
250V
Contact Voltage Dc Nom
30V
Contact Current Max
5A
Actuator Style
Round
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Illumination Type, Color
-
Illumination Voltage (nominal)
-
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
A165ES01
Z1427
Z1427
Installation
A165-E
J MOUNTING THE PANEL
After installing the Switch, snap in the Socket Unit from the back
of the panel.
1. Installing the Switch
Attach rubber packing or the Yellow Plate onto the Switch from its
terminal side. Insert the Switch into the panel from the front.
Install the lock ring and mounting nut from the terminal side and
tighten.
Adjust the slits on the hole of rubber packing and Yellow Plate to
the protruding part of the unit.
Note: Rubber packing is not necessary when the Yellow Plate is
Tighten the nut to the torque of 0.29 to 0.49 N S m.
Case should be installed with its protruding part adjusted to the
slit of the panel hole.
Align the lock ring to the groove of the case so that the edge is
drawn to the panel side.
View 2
View 1
Lock hole
Rubber packing or yellow plate (sold separately)
used.
Cutout
Lock
Panel
Edge
Mounting nut
Lock ring
Mounting nut
Rubber packing
(attached to the prod-
uct) or yellow plate
(sold separately)
Lock ring
Panel
8
2. Mounting the Socket Unit
Snap on the Socket Unit to the Switch.
Make sure the Switch and the Socket Unit are in the proper
orientation. Align the thin indentations on the case with the white
pushbutton markings on the Socket Unit and press the parts
together.
3 Removing the Switch
Grip the part between the Switch holder of the case and the Switch
Unit using the A16Z-5080 Extractor, and pull to remove the Switch
Unit.
4. Installing the LED Lamp
When mounting the Lamp, make sure it is facing the direction
shown in the following diagram. Insert the Lamp while matching
the protruding part of the Lamp and the small guides on the outer
surface of the case.
Protruding part
Extractor
(A16Z-5080)