D5A-8511 Omron, D5A-8511 Datasheet - Page 7

• Manufacturer Part Number: D5A-8511
• Description: LmitSw3micTpPlngrSldSt 3.9N 3m
• Manufacturer: Omron
• Type: High-Precision Switchr

Specifications of D5A-8511

• Contact Rating: 24 Volts
• Actuator: Plunger
• Operating Force: 3.93 N
• Termination Style: Lug
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

D5A
Precautions
J HANDLING OF FIBER CABLE
Do not pull or impose any force exceeding 29.42 N on the fiber
cable.
Make sure that the bending radius of the fiber cable is as large as
possible and at least 25 mm.
The 40-mm portion of the fiber cable on the connector end as
shown below must not be bent.
Do not impose compressing loads on the fiber cable.
J MOUNTING
For the mounting dimensions, refer to the following figures and tables.
Note: Do not tighten the nut with too much force. Be sure to apply the clamping torque shown in this table.
When mounting the switch to a panel, be sure to use a
toothed lock washer (included with M5, M8, and M16 types
only). Use the washer on the panel surface opposite the
object to be detected by the switch.
B
M5
M8
M16
Slim
Limit
C
Type
A
A
A
B
C
0.98 N S m max.
2.94 N S m max.
9.81 N S m max.
0.29 N S m max. (M2.6 screw)
1.47 N S m max. (M4 screw)
B
R25 mm min.
40 mm min.
Dimensions
Mounting hole
Panel thickness
Toothed lock washer
A
B
Clamping torque
Mounting pitch
Tapping
Mounting hole
Dimensions
5.2±0.1 mm dia.
3 to 10 mm
10 mm dia.
M5
The fiber cable can be cut with OMRON’s E39-F4 Cutting Tool.
Do not impose any force exceeding 29.42 N on the cable, or the
cable may break. Make sure that the bending radius of the cable
is at least 20 mm.
Object
to be
detected
8.2±0.1 mm dia.
5 to 8 mm
15 mm dia.
12±0.2 mm
M2.6
2.8
Contact
output
+0.2 °
--0 °
mm dia.
Toothed lock washer
Slim
M8
Nut
5 to 13 mm
Solid-state
output
Nylon clip
Fiber cable
16.2±0.1 mm dia.
10 to 17 mm
26 mm dia.
20±0.2 mm
M4
4.2
+0.2 °
--0 °
mm dia.
Limit
M16
D5A
7