X-10GQ-B Omron, X-10GQ-B Datasheet
![BASIC SWITCH](/photos/32/88/328806/x-10g_t_sml.jpg)
X-10GQ-B
Specifications of X-10GQ-B
Related parts for X-10GQ-B
X-10GQ-B Summary of contents
Page 1
... Screw Terminal terminal Model Actuator X-10G-B Hinge lever X-10GS-B Low-force hinge lever Short hinge roller X-10GD-B lever X-10GQ-B Hinge roller lever Reverse hinge lever X-10GQ22-B Reverse short hinge X-10GQ21-B * roller lever Reverse hinge roller * lever X-10GL-B * The plungers of reverse-type models are continuously pressed by the X-10GW21-B compression coil springs and the plungers are freed by operating the levers ...
Page 2
... The above electrical ratings also apply to the AC voltage. 6. With the reverse-type models (X-10GM@), the normally closed circuits and normally open circuits are reversed. 7. The ratings values apply under the following test conditions: (1) Ambient temperature: 20±2°C (2) Ambient humidity: 65±5%RH (3) Operating frequency: 20 operations/min ■ ...
Page 3
... Note: Mount using either the side mounting holes or the panel mount plunger, not both. If using the side mounting holes, then remove the hexagonal nut(s) from the panel mount plunger. Accessories (Terminal Covers, Actuators, and Separators): Refer to ‘Z/A/X/DZ Common Accessories’ datasheet ■ ...
Page 4
... Note: Do not use both the M12 mounting screw and the mounting holes in the case at the same time. Doing so will cause stress to be applied to the Switch, possibly damaging the case or cover. 4.8 *2 *1. Stainless-steel spring lever *2. Three vent holes X-10GS-B X-10GD-B X-10GQ-B 510 gf 510 gf 510 gf 114 gf 114 gf 114 gf 0.9 mm 0.9 mm ...
Page 5
... Note: 1. All drawings show the switches with screw terminals. For solder terminals, remove the “-B” from the end of the part number 2. Unless otherwise specified, all units are in millimeters and a tolerance of ± 0.4 mm applies to all dimensions. Short Hinge Lever X-10GW21-B 26 ...
Page 6
... Safety Precautions Be sure to read the precautions and information common to all Snap Action and Detection Switches, contained in the Technical User’s Guide, “Snap Action Switches, Technical Information” for correct use. Precautions for Safe Use Terminal Connection When soldering lead wires to the Switch, make sure that the capacity of the soldering iron maximum ...
Page 7
... X General-purpose Basic Switch MEMO ...
Page 8
... To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527. OMRON ELECTRONIC COMPONENTS LLC 55 E. Commerce Drive, Suite B Schaumburg, IL 60173 847-882-2288 11/10 Cat. No. X303-E-1 General-purpose Basic Switch OMRON ON-LINE Global - http://www.omron.com USA - http://www.components.omron.com Specifications subject to change without notice X ...