WM8711LGEFL/R Wolfson Microelectronics, WM8711LGEFL/R Datasheet - Page 17

• Manufacturer Part Number: WM8711LGEFL/R
• Description: Audio D/A Converter ICs Stereo DAC with H/P Line-In
• Manufacturer: Wolfson Microelectronics

Specifications of WM8711LGEFL/R

• Operating Supply Voltage: 1.8 V to 3.6 V, 1.42 V to 3.6 V
• Operating Temperature Range: - 25 C to + 85 C
• Mounting Style: SMD/SMT
• Package / Case: QFN-28
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Production Data
w
The scheme of the circuit is shown in Figure 10.
Figure 10 Headphone Amplifier Schematic
LHPOUT and RHPOUT volumes can be independently adjusted under software control using the
LHPVOL[6:0] and RHPVOL[6:0] bits respectively of the headphone output control registers. The
adjustment is logarithmic with an 80dB range in 1dB steps from +6dB to –73dB.
The headphone outputs can be separately muted by writing codes less than 0110000 to LHPVOL[6:0]
or RHPVO[6:0]L bits. Whenever the headphone outputs are muted or the device placed into standby
mode, the DC voltage is maintained at the line outputs to prevent any audible clicks from being
present.
A zero cross detect circuit is provided at the input to the headphones under the control of the LZCEN
and RZCEN bits of the headphone output control register. Using these controls the volume control
values are only updated when the input signal to the gain stage is close to the analogue ground level.
This minimises and audible clicks and zipper noise as the gain values are changed or the device
muted. Note that this circuit has no time out so if only DC levels are being applied to the gain stage
input of more than approximately 20mV, then the gain will not be updated. This zero cross function is
enabled when the LZCEN and RZCEN bit is set high during a volume register write. If there is
concern that a DC level may have blocked a volume change (one made with LZCEN or RZCEN set
high) then a subsequent volume write of the same value, but with the LZCEN or RZCEN bit set low
will force a volume update, regardless of the DC level.
LHPOUT and RHPOUT volume and zero-cross setting can be changed independently. Alternatively,
the user can lock the two channels together, allowing both to be updated simultaneously, halving the
number of serial writes required, provided that the same gain is needed for both channels. This is
achieved through writing to the HPBOTH bit of the control register. Setting LRHPBOTH whilst writing
to LHPVOL and LZCEN will simultaneously update the Right Headphone controls similarly. The
corresponding effect on updating RLHPBOTH is also achieved.
LINEOUT
DAC VIA
FROM
VMID
PD, Rev 4.5, August 2011
HPOUT
WM8711L
17