95ACC1220 IDEC, 95ACC1220 Datasheet - Page 8

• Manufacturer Part Number: 95ACC1220
• Description: Lens
• Manufacturer: IDEC

Specifications of 95ACC1220

• Focal Length: 40mm
• For Use With: TL46, LD46
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

232
Installation: If a sensor is installed so that the laser beam may shine or refl ect
into the eyes of a person passing by or working in the vicinity, place an opaque
sheet of material in front of the beam to prevent potential eye injury. For people
working near a laser sensor, protective glasses which screen out a signifi cant
amount of the harmful radiation are recommended at all times.
All laser sensors also include a remote interlock terminal which can be used to
turn the laser on or off with an external switch, as required, to operate the sen-
sor safely from a remote location.
To avoid exposure to harmful radiation, never disassemble a laser sensor.
WARNING: Do not allow class IIIa and IIIb laser beams to shine directly into the
eyes. Do not allow lasers to refl ect from a glossy, shiny, or refl ective surface into
the eyes.
Labelling: IDEC laser sensors include CDRH-approved safety warnings shown
below, in compliance with federal regulations of the Center for Devices and
Radiological Health.
MX1C Miniature Laser Sensor:
Class IIIa Laser (670nm) Visible Beam
All Laser Sensors:
Identifi cation and Certifi cation
MX1C Visible Laser:
Aperture Warning
mfd.: FEBRUARY 1997
Product conforms to
21 CFR1040
AVOID EXPOSURE –
Laser light is emitted
from this aperture.
Laser Safety
Laser Safety Information
www.idec.com
Sensors