72-7730 CALIBRATED TENMA, 72-7730 CALIBRATED Datasheet - Page 10

• Manufacturer Part Number: 72-7730 CALIBRATED
• Description: MULTIMETER DIGITAL HANDHELD, 4-1/2 DIGIT
• Manufacturer: TENMA

Specifications of 72-7730 CALIBRATED

• Dmm Type: Handheld
• Voltage Measuring Range Dc: 200mV - 1000V
• Voltage Measuring Range Ac: 2V - 1000V
• Current Measuring Range Dc: 200µA To 10A
• Current Measuring Range Ac: 200µA To 10A
• Lead Free Status / RoHS Status: na

Model 72-7730: OPERATING MANUAL
Safety Information
This Meter complies with the standards IEC61010 safety
measurement requirement: in pollution degree 2,
overvoltage category (CAT. III 1000V, CAT.IV 600V)
and double insulation.
CAT. III: Distribution level, fixed installation, with smaller
transient overvoltage than CAT. IV
CAT.IV: Primary supply level, overhead lines, cable
systems etc.
Use the Meter only as specified in this operating manual,
otherwise the protection provided by the Meter may be
impaired.
In this manual, a Warning identifies conditions and
actions that may pose hazards to the user, or may
damage the Meter or the equipment under test.
A Note identifies the information that user should pay
attention to.
International electrical symbols used on the Meter and
in this Operating Manual are explained on page 9.
Rules For Safe Operation
To avoid possible electric shock or personal injury,
and to avoid possible damage to the Meter or to the
equipment under test, adhere to the following rules:
l
l
l
l
Before using the Meter inspect the case. Do not
use the Meter if it is damaged or the case (or part
of the case) is removed. Look for cracks or missing
plastic. Pay attention to the insulation around the
connectors.
Inspect the test leads for damaged insulation or
exposed metal. Check the test leads for continuity.
number or electrical specifications before using the
Meter.
Do not apply more than the rated voltage, as marked
on the Meter, between the terminals or between any
terminal and grounding.
The rotary switch should be placed in the right
position and no any changeover of range shall be
made during measurement is conducted to prevent
damage of the Meter.
Replace damaged test leads with identical model
Warning
7